![]() |
Register or Log In To remove these advertisements. |
|
|
![]() |
|
Thread Tools | Display Modes |
|
![]() |
#1 |
Registered User
Join Date: Jul 2001
Location: Neenah, WI
Posts: 327
|
How do you Remove an AT cross member?!
I'm parting out a donor truck to convert my 6cyl 3 on the tree to an V-8 TH350 and I need the cross memer from the donor truck. The rivets / bolts are out, but it seems to be wedged too tight between the frame rails. I was figuring I would rotate it and get it to fall out, but that doesn't seem work.
Any thoughts would be appreciated. Thanks Brian |
![]() |
![]() |
![]() |
#2 |
Watch out for your cornhole !
![]() Join Date: Jun 2003
Location: Azle, Texas
Posts: 14,162
|
Hammer and a block of wood, they usually wedge in there. The crossmememer does need to rotate to fall out from between the frame rails
__________________
I'm on the Instagram- @Gearhead_Kevin |
![]() |
![]() |
![]() |
#3 |
Registered User
Join Date: Jul 2001
Location: Neenah, WI
Posts: 327
|
Maybe rotate wasn't the right word....possibly twist is more appropriate. None the less drive one side forward and the other back and it should come out of there aye?
|
![]() |
![]() |
![]() |
#4 |
.........................
Join Date: Nov 2001
Location: benton, ky
Posts: 288
|
Thats how I installed mine, Im sure reverse is the same. Hit one side then the other. Might be easier if its a junk truck, can cut the brake cables.
__________________
1971 LWB Chevy C-10 350/350 3:42 eaton ![]() |
![]() |
![]() |
![]() |
Bookmarks |
|
|