![]() |
|
![]() |
#1 |
72GMC51
Join Date: Jul 2004
Location: Minnesota
Posts: 233
|
uneven suspension
All right, I rebuilt the rear end new Eaton posi, left the 4:11 in, put new gas shocks, clean and painted track bar and trailering arms and installed new bushings, a sway bar, installed new 3" drop springs, brakes etc. The problem is the drives side at the rear wheel well is 31' the pass side is 32" ??????????????.
![]() ![]() Thanks JC
__________________
72 GMC 2wd 1/2 long 350 700r4 A/C PS PB 4:10. Are they ever really finished ![]() |
![]() |
![]() |
![]() |
#2 |
Cantankerous Geezer
Join Date: Aug 2002
Location: Bel Aire, KS
Posts: 6,264
|
Have you measured the floor to frame or the body? Frame will tell you more, especially near the spring attach points. Body can be off in relation to the frame.
If it's coil springs are the coils seated? Have you driven the truck, helping get things seated? When I did the spring change on mine, it all looked good until I drove it around the block. One of the coils had not been in right and rotated.
__________________
Fred There is no such thing as too much cam...just not enough engine. ![]() |
![]() |
![]() |
![]() |
#3 |
Registered User
Join Date: Jun 2005
Location: Sacramento CA
Posts: 1,255
|
*Check the coil springs to see if they are seated correctly
*Make sure the rear swaybar is not binding. Release the endlinks. *Make sure the panhard bar is not binding. *Did you unbolt the bed at anytime? Basically check anything you added or changed.
__________________
Got bored, sold everthing. Got bored, looking for a 1960-66 C-10. Want to build my last truck. |
![]() |
![]() |
![]() |
#4 |
Senior Member
Join Date: Sep 2004
Location: Terrell, TX
Posts: 1,967
|
I noticed the 'new' S-10 my wife bought was like that...3/4" lower on the drivers side...so's my C-20 and so's my Elky...each a little lower on the driver's side. I'd be willin' to bet it's normal since there's someone on the driver's side 100% of the time the truck is driven and the passenger side is filled less than half that time.
__________________
Kelly '05 GMC Sierra SLE Z71 Bone stock except for new bed rail caps. Last edited by Gray Ghost; 07-22-2005 at 07:42 AM. |
![]() |
![]() |
![]() |
#5 |
Senior Member
Join Date: Jul 2004
Location: Sweden
Posts: 833
|
My 71 C20 was a about 1/2-3/4 lower on the passenger side in the rear.
Checked everything, I even took out both leaf spring packs and changed side for them but the truck still sat a little lower on pass side. I ended up putting shims between the frame and the bed crossmembers to get it straight.
__________________
Mats.. ---------------------------------------------------- 1971 Cheyenne Super Custom Camper 475CBB/TH400/AC 1992 Silverado Sport Truck 1988 Silverado 2500 Ext Longbed 4x4 2001 GMC Sierra SLT 4x4 1990 Chevrolet K3500 1965 Pontiac Grand Prix 1980 Z 28 350/4-speed/AC/T-top 1980 Camaro Coupe V6/3-speed 1979 Buick Century Wagon |
![]() |
![]() |
![]() |
Bookmarks |
|
|