replacing dash

[BBCamaro]

How big of a project is to remove the dash from a 72 truck?? I`ve never done this before and looking for some pointers before i start.... Thanks

[rocknss]

The easiest way to remove the dash with the windshield in is remove the dash pad then cut the dash were the dash pad would be. Then remove the three bolts on each side of the dash and remove dash.

Cut the section off the replacement dash that's still in the cab and weld the two pieces together after bolting in the dash.

Its easier this way because the dash is spot welding to the cab.

[Coley]

If you mean the gauge assembly....it is not difficult if you know what to do and what tools to use.
First things first tho', is this what you mean by removing the dash or are you referring to the metalwork portion?
Coley

[BBCamaro]

Im talking about the metal dash its cut and I would like to replace it and was wondering how it comes out.Thanks

[70c10-08]

I dont remember how many spotwelds are in the bottom part of the windeshield i wanna say 15 20ish i drilled em out and pryed it out and removed the bolts on the side on my junk 1970 non ac cab and my 1967 ac cab I converted my 67 small window ac cab to a 1970 small window non ac cab

[RenoKeene]

I see this is your 2nd post....welcome.
If your dash is cut at the radio the easiest way to fix it is to strip everything off and cut it at the guages, glovebox and across the slots where the dash pad mounts. You can pick up a uncut section on the parts board for cheap and have it welded in, thats what I did. You could also cut it all the way across the slots and unbolt it at each end. I'd stay away from the spot welds.
Here is a pic of mine.....can you tell where it was fixed?

[cdowns]

Originally Posted by rocknss

The easiest way to remove the dash with the windshield in is remove the dash pad then cut the dash were the dash pad would be. Then remove the three bolts on each side of the dash and remove dash.

Cut the section off the replacement dash that's still in the cab and weld the two pieces together after bolting in the dash.

Its easier this way because the dash is spot welding to the cab.

i've found that it is by far easier this way he explains it good

[DaHos]

Replacement piece - cut high
Dash to repair - cut low

or swap, either way you then have plenty of metal to trim for proper fitment.

[68gmsee]

Originally Posted by DaHos

Replacement piece - cut high
Dash to repair - cut low

You then have plenty of metal to trim for proper fitment.

Good point, but I still want to know where others have cut. Is it better to cut above the slots or below or right down the middle?