Please Help!!!

[1971ChevyTruck]

Daughter was out in the garage with me last night and some how managed to drop a plastic wire connector in one of the cooling holes in the head...any ideas on how to get it out without removing the intake and head

[beautimus]

first, are you sure it is a cooling passage?
if its an air intake passage the connector should stop at the valve pocket, unless it meets an open valve.
first thing i would try would be to use a piece of coat hanger wire and make a ball of masking tape on it, sticky side out, and try to pull it out.
the only other idea i can think of is compressed air but i am not sure that would be the way to go. good luck.

[Sport/Truck]

I’m thinking a vacuum cleaner might work. It will need to be an open hole somewhere down line for this to work well ~ (air flow).

I went through this a few weeks ago with my 20 MO son….only it was needle bearings!!!
I ended up pulling the heads back off to check.
Ended up not being any thing in there, but better safe than sorry.
s/t

[68gmsee]

First, can you see it? If you can, you'll have to come with some ingenuity.
Sticky substances on coat hangers as beautimus mentioned or some suction device. Maybe a small rubber hose attached to the suction side of a small vacuum cleaner.

[Spoof]

I'm thinkin' compressed air...but also that maybe YOU dropped it.