Register or Log In To remove these advertisements. |
|
|
|
Thread Tools | Display Modes |
|
01-03-2013, 02:44 PM | #1 |
Junior Member
Join Date: Apr 2005
Location: Novi, Michigan
Posts: 55
|
gas gauge electrical ?
Hi folks, started the rebuilding project of my 1972/1967/1969 C10 short step-side this winter. Dropped the rear 5", front 3", cut out the cancer and put in new sheetmetal. Keeping it simple and straight forward. Thinking I would like to use the large fuel gauge in the normal position (upper right side of bezel) and realized I cut the ribbon to the gauge to fit the tach and other after market gauges in the original bezel.
How can I run the original large fuel gauge without the electrical ribbon ? Thanks for your replies. |
01-03-2013, 03:12 PM | #2 |
Registered User
Join Date: Feb 2011
Location: Modesto, CA
Posts: 2,189
|
Re: gas gauge electrical ?
Just bypass the circuit board and route your own wires. You can even follow the wiring to the spots on the gauge connector so you wouldn't need a schematic. You'd have to splice into the wiring somewhere though.
Posted via Mobile Device |
Bookmarks |
|
|