![]() |
Register or Log In To remove these advertisements. |
|
|
![]() |
|
Thread Tools | Display Modes |
|
![]() |
#1 |
Premium Level Member
Join Date: Aug 2004
Location: Northern CA
Posts: 829
|
Need a pic of power steering pump w/brackets installed
I am missing a bracket for my power steering pump. I have the pump, its cradled in a big bracket, but i'm sure there is another bracket I'm missing(?). I posted on here looking for one, but no one was sure what I needed. I figure if I can get a pic, then I can ask for the right part.
thanks, jakeslim |
![]() |
![]() |
![]() |
#2 |
its all about the +6 inches
Join Date: Jan 2001
Location: Hilliard Ohio
Posts: 2,693
|
What year? what engine? What size pump? What side is the alt on?
|
![]() |
![]() |
![]() |
#3 |
Cantankerous Geezer
Join Date: Aug 2002
Location: Bel Aire, KS
Posts: 6,264
|
Here's a shot of the bracket on my 69, the pump bracket bolts to this one.
![]()
__________________
Fred There is no such thing as too much cam...just not enough engine. ![]() |
![]() |
![]() |
![]() |
#4 |
its all about the +6 inches
Join Date: Jan 2001
Location: Hilliard Ohio
Posts: 2,693
|
That is the small block with the short water pump...as stock (alt on drivers side)
|
![]() |
![]() |
![]() |
#5 | |
Premium Level Member
Join Date: Aug 2004
Location: Northern CA
Posts: 829
|
Quote:
thanks for the help, jakeslim Last edited by jakeslim; 11-11-2004 at 01:01 AM. |
|
![]() |
![]() |
![]() |
#6 |
its all about the +6 inches
Join Date: Jan 2001
Location: Hilliard Ohio
Posts: 2,693
|
Yup, bols to the motor mount, and that is where they commonly break too.
|
![]() |
![]() |
![]() |
#7 |
Senior Member
Join Date: Jan 2001
Location: Virginia Beach, Va, USA
Posts: 1,677
|
Where is bolts.
I have a small block. No pics. My power steering pump bolts on the left side. It actually has a bolt with a standoff and washers. Kerry
__________________
1969 Chevelle 1990 IROC Z Convertible 2002 Silverado LT |
![]() |
![]() |
![]() |
#8 |
Registered User
Join Date: Nov 2003
Location: Alexandria, VA
Posts: 1,534
|
Nice looking engine Fred T. There should be a cast iron cradle type bracket that mounts in front of the sheet metal bracket in Fred T's pic.
__________________
'72 GMC SWB C1500 Custom, frame-off in progress. 383 SBC, 9:1CR, Comp Cams XE262H, Scat internal balanced crank, Eagle SIR 6" rods, Keith Black dish pistons, Dart Iron Eagle 72/180 heads, Weiand Stealth intake, Stewart stage I water pump, Holley 4bbl vac sec, TH350 with B&M Shift Improver Kit. 12 bolt positraction. ![]() ![]() ![]() |
![]() |
![]() |
![]() |
Bookmarks |
|
|