|
Register or Log In To remove these advertisements. |
|
|
|
|||||||
 |
|
|
Thread Tools | Display Modes |
|
|
10-11-2020, 07:32 PM
|
#1 |
|
Registered User
Join Date: Feb 2013
Location: GA
Posts: 1,313
|
Deluxe heater control assembly into the non deluxe dash question
Now that I am going to have the Vintage Air Sure Fit the assemly Im restoring looks like I need to bend the screw mount tabs and find the right screws and j clips to mount things up. Anyone able to tell me how they manage this? The install manual shows a jnut at the top of the assembly?
|
|
|
|
10-11-2020, 08:37 PM
|
#2 |
|
Moderator
  
Join Date: Aug 2011
Location: China Spring, TX
Posts: 7,280
|
Re: Deluxe heater control assembly into the non deluxe dash question
As I recall Vintage Air has instructions.
__________________
Master Chief, US Navy, Retired 1964 C10 Step-side Short Bed - In Progress 2009 2500HD Duramax LTZ 1948 GMC Panel 1956 Big Window Stepside 1953 5 Window Chevy Stepside 1932 Coupe New Seat Foam for Bench Seats? |
|
|
|
|
10-11-2020, 08:49 PM
|
#3 |
|
Senior Member
 
Join Date: Feb 2014
Location: new smyrna beach fl / 29 palms cal
Posts: 1,727
|
Re: Deluxe heater control assembly into the non deluxe dash question
You need 2 #6 screws and U nuts bend the tabs so they are parallel with deluxe controls. The controls have a bracket that bolts to bottom side of the dash
__________________
Hand made A/C vent manifolds for 64-66 trucks adapts any aftermarket A/C to OEM vent |
|
|
|
|
10-11-2020, 11:13 PM
|
#4 |
|
Registered User
Join Date: Feb 2013
Location: GA
Posts: 1,313
|
Re: Deluxe heater control assembly into the non deluxe dash question
It looked like the tabs should be bent, is there a trick to doing it to not have them misalign or wreck the dash? I was going to use vise grips and just clamp close to the dash and bend away. Ill look for the #6 u nuts and screws thanks!
|
|
|
|
|
10-13-2020, 09:47 AM
|
#5 |
|
Active Member
 Join Date: Aug 2012
Location: Central Illinois
Posts: 103
|
Re: Deluxe heater control assembly into the non deluxe dash question
Put some masking tape on the tabs and then use vise grips to bend them. Clamp the vise grips on about as far as you can.
|
|
|
|
|
10-13-2020, 07:41 PM
|
#6 |
|
Registered User
Join Date: Feb 2013
Location: GA
Posts: 1,313
|
Re: Deluxe heater control assembly into the non deluxe dash question
Ive bent the tabs and tried the j clips and they end up shimming the unit down causing the unit no to fit so I just rested them on top and thread the screw through and got that worked out.
|
|
|
|
|
| Bookmarks |
|
|
Hybrid Mode
