|
Register or Log In To remove these advertisements. |
|
|
|
|||||||
 |
|
|
Thread Tools | Display Modes |
|
|
12-27-2003, 06:21 PM
|
#1 |
|
Registered User
Join Date: Dec 2003
Location: Land Of 10,000 Misquitos
Posts: 134
|
64 1/2 ton Pulling Rear Axel
Would someone tell me how to pull the rear axels on a 64 Chevy 1/2 ton? I pulled the cover on the rear end, but don't see any c-clips or the likes. Don't believe I see a retainer on the brake backing plate.....do I? Thanks for any help, Tom
|
|
|
|
12-27-2003, 11:00 PM
|
#2 |
|
Registered User
Join Date: Aug 2003
Location: stallings,nc
Posts: 401
|
there should be a large shaft maybe 3/4" in diameter and around four inches long in the middle.its held in place with a small bolt.remove the bolt.slide the shaft out.then push the axle in and you will see the clip.remove the clip and the axle will pull out.
|
|
|
|
|
12-28-2003, 12:23 AM
|
#3 |
|
Registered User
Join Date: Dec 2003
Location: Land Of 10,000 Misquitos
Posts: 134
|
Many Thanks Zenish, will look it over again in the a.m.
|
|
|
|
|
01-01-2004, 10:42 PM
|
#4 |
|
Registered User
Join Date: May 2001
Location: Liberal, Ks, Us
Posts: 1,091
|
Zenish is correct.
|
|
|
|
|
01-02-2004, 08:46 AM
|
#5 |
|
Registered User
Join Date: Dec 2003
Location: Land Of 10,000 Misquitos
Posts: 134
|
Zenish was correct
Zenish was correct on the axel removal. Axels are out, new seals going in today. Thanks.
|
|
|
|
|
| Bookmarks |
|
|
Hybrid Mode
