![]() |
|
![]() |
#1 |
Registered User
Join Date: Feb 2010
Location: Louisville ky
Posts: 398
|
Driveshaft
I have a 72 c20 i broke the yoke on the rear section of the 2 peice drive shaft, i need to know what other vehicles might have a drive shaft that will work or what i might have to do to switch to a single drive shaft. If anyone knows you huys will, i thank you in advance for any advice.
Posted via Mobile Device |
![]() |
![]() |
![]() |
#2 |
Registered User
Join Date: Feb 2010
Location: Louisville ky
Posts: 398
|
Re: Driveshaft
Noone?
Posted via Mobile Device |
![]() |
![]() |
![]() |
#3 |
Registered User
Join Date: Mar 2010
Location: Minnetonka, MN
Posts: 409
|
Re: Driveshaft
Driveshafts generally arent plug and play. you'll have to find one from another 67-72 c20 with the same motor/trans/rear end combo. check the 4 sale section here....you might get lucky.
A better bet might just be to have a driveline shop make a new section to replace the damaged one. Also, I have heard on here that a one-piece shaft will not work with long beds because the crossmember where the carrier used to be doesn't allow enough downward travel for the suspension. someone can refute that though. ![]() good luck!
__________________
1971 C-20 350/350 |
![]() |
![]() |
![]() |
#4 |
Registered User
Join Date: Feb 2010
Location: Louisville ky
Posts: 398
|
Re: Driveshaft
I Was afraid of that, i knew that alot of gm parts from alot of years could interchange i was hoping i would get lucky, thanks for the help
Posted via Mobile Device |
![]() |
![]() |
![]() |
#5 |
Registered User
Join Date: Feb 2010
Location: Louisville ky
Posts: 398
|
Re: Driveshaft
Oh and if it help i has the factory 350 4spd, idk which one, and i wanna say 4:5? Rear end
Posted via Mobile Device |
![]() |
![]() |
![]() |
Bookmarks |
|
|