![]() |
Register or Log In To remove these advertisements. |
|
|
![]() |
|
Thread Tools | Display Modes |
|
![]() |
#1 |
Registered User
Join Date: Feb 2007
Location: Cali Central Coast
Posts: 5,191
|
Has anyone changed your front wheel lugs out?
I am going to attempt this but have never done it before. The old ones are original and pretty chingered up. Is there a trick to it, or is it just pounding them out with a BFD? Do you need any special tools? It's a '67 with drums, if that makes any difference.
__________________
'67 SWB Fleetside ZZ4/350/Tremec 5-speed/4link/Scott's IFS - and fun as heck! SOLD ![]() Click here to support the board Philippians 4: 6-7 |
![]() |
![]() |
![]() |
#2 |
Registered User
Join Date: Aug 2002
Location: Muskogee, Oklahoma
Posts: 2,914
|
Re: Has anyone changed your front wheel lugs out?
You are talking about the studs right? I just pound them out.
|
![]() |
![]() |
![]() |
#3 |
Senior Member
![]() Join Date: Feb 2010
Location: Kennesaw, GA
Posts: 288
|
Re: Has anyone changed your front wheel lugs out?
It's easier with the hubs off, because you'll need to drive the new ones in and make sure they are seated as well. Some folks pull the new ones in place with the lugnuts, but I've never had good luck with it.
|
![]() |
![]() |
![]() |
#4 |
Senior Member
![]() Join Date: Jan 2001
Location: Orem, Utah
Posts: 7,907
|
Re: Has anyone changed your front wheel lugs out?
The easy way is on the shop press, but if you don't have one of those, a 3-pound sledge does a quick job of getting them out. To install new ones, you can just pull them in with a lug nut, but I would use a small stack of washers under the nut (2 or 3 should do) to make sure it's completely seated.
|
![]() |
![]() |
![]() |
#5 |
Registered User
Join Date: Aug 2009
Location: St. Paul MN.
Posts: 1,996
|
Re: Has anyone changed your front wheel lugs out?
Another trick is to push the studs through the hub and a steel wheel and tighten the lug nuts down.
__________________
Fuzzy |
![]() |
![]() |
![]() |
Bookmarks |
|
|