![]() |
|
![]() |
#1 |
Registered User
Join Date: Oct 2010
Location: Tujunga, CA
Posts: 262
|
Power steering pump?
Hi guys,
Is the picture below my power steering pump? If so, how do I get the cover off to check the fluid? Also, why doesn't it look like the power steering pump on LMC's parts page? http://www.lmctruck.com/icatalog/cb/full.aspx?Page=136 [IMG] ![]()
__________________
Thanks, Emil 1972 Chevy C20 |
![]() |
![]() |
![]() |
#2 |
Registered User
Join Date: Sep 2005
Location: Smith Mountain Lake Virginia
Posts: 1,537
|
Re: Power steering pump?
Thats the master cylinder for your brake system and the larger part behind is the brake booster (uses vacuum). Power steering pump is at the front of the engine and driven by the belt(s).
__________________
"A cat will almost always blink when hit between the eyes with a ball peen hammer" (you don't always have to state the obvious) Wear your PPE! You can eat with false teeth but you can't see with a false eye. 1959 Studebaker Silverhawk 350/400 1972 C10 L6 3OTT 2005 F350 - Built - whew! |
![]() |
![]() |
![]() |
#3 |
Senior Member
Join Date: Nov 2003
Location: Brookings, SD
Posts: 10,497
|
Re: Power steering pump?
As mentioned above it's the master cylinder for the brakes. You flip the first wire clamp back toward you and the other toward the brake booster to get the cap off to check the brake fluid.
__________________
Some people are like slinkies, they aren't good for anything, but you can't help but smile when you see one tumble down the stairs. |
![]() |
![]() |
![]() |
#4 |
Senior Member
Join Date: Jan 2003
Location: daytonabeach
Posts: 22,956
|
Re: Power steering pump?
if you have power steering that pump is located at the front bottom of the engine on the drivers side it is powered by one of the fan belts it will have a cap that you unscrew and there's a dipstick attached to the cap sometimes to measure fluid in the pump
__________________
71c-10 350/2004r/4:11 lowered3/4 longbed/dead by hurricane MEANING OF DEATH::::: SOMEBODY ELSE GETS YOUR STUFF DONT BELIEVE EVERYTHING YOU THINK TAKE MY ADVISE;I DON'T USE IT ANYWAY |
![]() |
![]() |
![]() |
#5 |
Registered User
Join Date: Oct 2010
Location: Tujunga, CA
Posts: 262
|
Re: Power steering pump?
Ah, thanks guys! I tried the flip method, does it involve a little bit of muscle?
__________________
Thanks, Emil 1972 Chevy C20 |
![]() |
![]() |
![]() |
#6 |
Registered User
Join Date: Oct 2010
Location: Tujunga, CA
Posts: 262
|
Re: Power steering pump?
But the brake fluid is stored where I took a picture of, right? Or does the power steering pump have a separate reservoir that I have to add fluid to?
__________________
Thanks, Emil 1972 Chevy C20 |
![]() |
![]() |
![]() |
#7 |
Registered User
Join Date: Aug 2009
Location: Alden NY
Posts: 2,705
|
Re: Power steering pump?
Separate reservoir lower right front of engine (as you are standing in front of it). Check it with the engine off. It takes power steering fluid.
By the way, when you put your master cylinder cap back on, carefully push the portions of the rubber gasket in that may be hanging out back up in the cap.
__________________
1961 C1 Corvette 1959 El Camino 350 TPI, 9" 4 w disc 69 Blazer K5 - sold July '20 2021 Durango RT 5.7 |
![]() |
![]() |
![]() |
#8 |
Registered User
Join Date: Oct 2010
Location: Tujunga, CA
Posts: 262
|
Re: Power steering pump?
Thanks guys. I checked the power steering reservoir, it's good to go. For the life of me I can't take off the cover of the master cylinder. I tried to pull the wire clamps, but they don't want to clear the top of the cap. Help! Also, if the master cylinder fluid is low, I put brake fluid in it, correct?
__________________
Thanks, Emil 1972 Chevy C20 |
![]() |
![]() |
![]() |
#9 |
Senior Member
![]() Join Date: Oct 2005
Location: south carolina
Posts: 658
|
Re: Power steering pump?
Yes just the brake fluid is stored in the picture you are showing. The clamps may be tight or even stuck. The picture that I'm showing is of a newer model but the power steering reservoir is in the same general location. Hope this helps. See the round cap under the alternator. That is the power steering res. Righty tighty lefty loosey.
__________________
1972 chevy cheyenne 10,nothing special at the moment,Its a work in progress, Working on the engine, paint and body,engine, paint and body,now its the suspenion, ahh hell I'm about tired of working on it. Maybe it will be a rat rod. ![]() Last edited by roughedup72; 12-26-2010 at 08:53 PM. |
![]() |
![]() |
![]() |
#10 |
Senior Member
![]() Join Date: Oct 2005
Location: south carolina
Posts: 658
|
Re: Power steering pump?
Put a flat blade screwdriver under the front strap from the back side and lift the handle. HMMM. push/pull the handle to the front of the truck as to pry it open. Then repeat the step for the rear but put the tip of the screwdriver pointing towards the cab and lift the handle of the screwdriver.. I hope you can follow what I am trying to describe. You have to use it as leverage. Just be carefull not to stretch out your clips. They should be snug and not loose so that the brake fluid doesnt leak out.
__________________
1972 chevy cheyenne 10,nothing special at the moment,Its a work in progress, Working on the engine, paint and body,engine, paint and body,now its the suspenion, ahh hell I'm about tired of working on it. Maybe it will be a rat rod. ![]() |
![]() |
![]() |
![]() |
#11 |
Registered User
Join Date: Oct 2010
Location: Tujunga, CA
Posts: 262
|
Re: Power steering pump?
Great, I will try tomorrow. Thanks.
__________________
Thanks, Emil 1972 Chevy C20 |
![]() |
![]() |
![]() |
Bookmarks |
|
|