![]() |
|
![]() |
#1 |
Registered User
Join Date: Oct 2004
Posts: 141
|
will it fit
real quick question before I buy this thing does anyone know if a 11" flywheel will fit in a three speed bell housing. Do you know of any other problems going to match up a re-built 350 to the three speed with a hurst floor shifter and I think a 10" clutch system will get ribbed apart. dave
|
![]() |
![]() |
![]() |
#2 |
Registered User
Join Date: Apr 2000
Location: Leesburg, GA
Posts: 746
|
To my knowledge (and looking at Hollander), there was only one manual transmission bellhousing used on 68-72 Trucks no matter what engine/trans was installed. The 67 model used the same bellhousing as the 65-66 truck. Also, a 10" clutch only came on 6cyl trucks (the 6cyl HD clutch was 11"). All V-8's got a minimum of an 11" and some got HD 12" clutches. Hope this helps.
__________________
FOUNDING MEMBER OF THE DRUM BRAKE CLUB Second Owner 70 C-10 Second Owner 93 GMC C1500 Third Owner 99 C2500 Crew Cab Short Bed |
![]() |
![]() |
![]() |
#3 |
Still drivin' a Rat Rod
Join Date: Sep 2004
Location: Monett Missouri
Posts: 4,925
|
I think the diameter of the flywheels are the same except for the 10 inch,which is different,and requires a different starter.The 10" uses the 1 long1 short bolt starter,and the rest use the 2 long bolt starters,unless you have the cast bell for a 4 speed,then the starter bolts to the bellhousing.
__________________
Rusty Member #13872 Instead of saying.....you are a discomfort in the back of my front.....one should be able to say...... you are a pain in the *a$#* 71 GMC LWB 49 Chevy 85 Chevy G20 Check out my website Last edited by Brainchild; 03-10-2005 at 03:51 PM. |
![]() |
![]() |
![]() |
#4 |
Registered User
Join Date: Oct 2004
Posts: 141
|
thanks for the info, so if i change to a 11" flywheel and clutch I will have to change starters also and does anyone have a 350 with a 10" clutch system and do you have any problems Thanks again Dave
|
![]() |
![]() |
![]() |
#5 |
Still drivin' a Rat Rod
Join Date: Sep 2004
Location: Monett Missouri
Posts: 4,925
|
If your gonna do any hauling,or pulling at all I would go for the 11" clutch.
__________________
Rusty Member #13872 Instead of saying.....you are a discomfort in the back of my front.....one should be able to say...... you are a pain in the *a$#* 71 GMC LWB 49 Chevy 85 Chevy G20 Check out my website |
![]() |
![]() |
![]() |
Bookmarks |
|
|