|
Register or Log In To remove these advertisements. |
|
|
|
|||||||
 |
|
|
Thread Tools | Display Modes |
|
|
02-07-2007, 09:55 PM
|
#1 |
|
The Original HotRod KnifeMaker
 
Join Date: Jan 2007
Location: Tenino, Washington
Posts: 811
|
WTB 67-68 Driveline Seattle/Portland area
for a turbo 400 shortshaft, SWB, 2wd with leaf-spring rear end
Thanks, Dave |
|
|
|
02-07-2007, 10:23 PM
|
#2 |
|
Registered User
Join Date: Nov 2002
Location: Mt. Vernon, WA..
Posts: 2,322
|
Re: WTB 67-68 Driveline Seattle/Portland area
what length? are you needing the 400 yoke also?
|
|
|
|
|
02-08-2007, 12:02 AM
|
#3 |
|
The Original HotRod KnifeMaker
Join Date: Jan 2007
Location: Tenino, Washington
Posts: 811
|
Re: WTB 67-68 Driveline Seattle/Portland area
I haven't one that fits to measure- my original one is too short. Converted from 350/350 long-shaft to 396 and a 400 trans with short shaft-.
I do want the front yoke, also. Thanks, Dave |
|
|
|
|
02-08-2007, 07:49 PM
|
#4 |
|
Registered User
Join Date: Nov 2002
Location: Mt. Vernon, WA..
Posts: 2,322
|
Re: WTB 67-68 Driveline Seattle/Portland area
go lay under the truck and measure from center of cups on the rearend to the tail of the tranny and then subtract 2 or 3 inches, that'll be the center of the tranny yoke. I have 2 or 3 laying around here, but to be honest, you can get the measurement and go to the junkyard and find the right length. The one in my 67 shorty is out of a dodge van. Let me know, one of these might be the right length.
|
|
|
|
|
02-11-2007, 02:54 PM
|
#5 |
|
The Original HotRod KnifeMaker
Join Date: Jan 2007
Location: Tenino, Washington
Posts: 811
|
Re: WTB 67-68 Driveline Seattle/Portland area
ttt
__________________
Dave 69 GMC SWB 2WD 454 Turbo 400 |
|
|
|
|
02-27-2007, 11:52 PM
|
#6 |
|
The Original HotRod KnifeMaker
Join Date: Jan 2007
Location: Tenino, Washington
Posts: 811
|
Re: WTB 67-68 Driveline Seattle/Portland area
Got the new length measured- 60.25 end to end. If you have one would there be a way to get it near Olympia?
Thanks,
__________________
Dave 69 GMC SWB 2WD 454 Turbo 400 |
|
|
|
|
02-28-2007, 12:58 AM
|
#7 |
|
67 shorty
Join Date: Feb 2007
Location: Graham,Wa.
Posts: 190
|
Re: WTB 67-68 Driveline Seattle/Portland area
do you have the top mount or bottom mount carrier bearing? If you want a direct bolt up this matters, right?
__________________
67 SWB with enough parts to build two 
|
|
|
|
|
| Bookmarks |
|
|
Hybrid Mode
