|
|
|
07-07-2007, 12:04 PM
|
#1 |
|
Registered User
Join Date: Feb 2004
Location: Indiana
Posts: 158
|
Steering Help Anyone
Wanted to cleanup the lower steering shaft and put a new seal in what GM calls the pot joint or coupler joint (opposite the rag joint). Question is will the cross pin the two bearings ride on press out of the shaft. I did put some pressure on it (will a press) but saw no movement. Don't want to mess it up. Also where can I find a new seal. Oh yeah it's a 69 1/2T 2wd. Thanks.
|
|
|
|
07-08-2007, 07:58 AM
|
#2 |
|
Registered User
Join Date: Feb 2004
Location: Indiana
Posts: 158
|
Re: Steering Help Anyone
Anyone
|
|
|
|
|
07-09-2007, 04:53 AM
|
#3 |
|
Senior Member
Join Date: Jul 2001
Location: Muskegon,MI,USA
Posts: 6,026
|
Re: Steering Help Anyone
The service manual says to use an arbor press to press the pin out and not to drive it out with a hammer. So, according to the manual the pin can be removed by pressing it out.
Jim
__________________
1971 Shortbox step side 4x4, 350 sbc, 3:07 rear end 1965 Impala SS 400 sbc, Muncie rock crusher 1966 Impala SS 396 bbc, TH 400 1969 El Camino, 350 sbc, TH 350 1971 Snowplow built on a Blazer frame 1972 GMC Short bed, stepside, TH 400, 427 BBC |
|
|
|
 |
| Bookmarks |
|
|
Hybrid Mode
