|
|
|
03-14-2008, 03:05 AM
|
#1 |
|
Registered User
 
Join Date: Jan 2005
Location: Illinois
Posts: 1,006
|
Soda Blasting
I just bought soda blasting equipment--and it is a heck of a lot better than sand blasting...anyone else done soda blasting?? Is there any trick or secrets??
|
|
|
|
03-14-2008, 03:07 AM
|
#2 |
|
its all about the +6 inches
Join Date: Jan 2001
Location: Hilliard Ohio
Posts: 2,693
|
Re: Soda Blasting
You may want to talk to some paint people before going any further. Lots of problems have been popping up with soda blasting.
|
|
|
|
|
03-14-2008, 03:50 AM
|
#3 |
|
Senior Member
Join Date: Jan 2003
Location: daytonabeach
Posts: 22,956
|
Re: Soda Blasting
lots of soda blasters went out of business around here cause of all the law suits from paint failure and advanced body rot due to soda blasting
__________________
71c-10 350/2004r/4:11 lowered3/4 longbed/dead by hurricane MEANING OF DEATH::::: SOMEBODY ELSE GETS YOUR STUFF DONT BELIEVE EVERYTHING YOU THINK TAKE MY ADVISE;I DON'T USE IT ANYWAY |
|
|
|
|
03-14-2008, 05:23 AM
|
#4 |
|
Rice Killing 101
Join Date: Feb 2008
Location: aliso viejo California
Posts: 107
|
Re: Soda Blasting
yea make sure u have a good ground wire, wash ur pieces of thoroughly and then go over every knick with a towel and brake clean then lacqeur it or however u spell it
__________________
 distrubin the peace since i got the thing and broke the origianl radio on 95.5 classic rock  Ride: 1968 c20 lwb 327(orig motor)/np435/eaton 4.10 w/posi puttin in a 496 rebuilding trans need to rebuild diff :| need to start takin pics and start a project thread 
|
|
|
|
 |
| Bookmarks |
|
|
Hybrid Mode
