![]() |
Register or Log In To remove these advertisements. |
|
|
![]() |
|
Thread Tools | Display Modes |
|
![]() |
#1 |
Active Member
![]() Join Date: May 2013
Location: Hanover,PA
Posts: 162
|
Square body Engine mounts
Does anyone know if the small block clam shell engine mounts for a 73 or newer would work in the 67-72? Including the frame mounts. I don't like the mounts on the 67-72 and looking to change it while I have the engine out.
|
![]() |
![]() |
![]() |
#2 |
Registered User
Join Date: Feb 2010
Location: rochelle il.
Posts: 356
|
Re: Square body Engine mounts
That is what i put in mine it was out of a 75.Have to drill a couple holes in the crossmember .Perfect timing just getting mine together.
|
![]() |
![]() |
![]() |
#3 |
Active Member
![]() Join Date: May 2013
Location: Hanover,PA
Posts: 162
|
Re: Square body Engine mounts
|
![]() |
![]() |
![]() |
#4 |
Registered User
Join Date: Feb 2010
Location: rochelle il.
Posts: 356
|
Re: Square body Engine mounts
Upper part lines up the lower you will have to drill one hole each side.
|
![]() |
![]() |
![]() |
#5 |
Senior Member
![]() Join Date: Dec 2013
Location: Gods country East,Tn
Posts: 8,545
|
Re: Square body Engine mounts
__________________
![]() 1967 Factory short bed - Old school '71 - 350 / 4bolt / 487 heads / Edelbrock C3BX Muncie M-22 4 speed / Hurst Comp plus Factory 12 bolt posi 3.73 / 255-70-15 Smoothed firewall / Factory cowl induction Power disc brakes / power steering / 3.5-5" drop |
![]() |
![]() |
![]() |
#6 | |
Active Member
![]() Join Date: May 2013
Location: Hanover,PA
Posts: 162
|
Re: Square body Engine mounts
Damn. I see I was too lat for these.
Quote:
|
|
![]() |
![]() |
![]() |
#7 | |
The Older Generation
![]() ![]() ![]() Join Date: Aug 2006
Location: Montezuma, Iowa
Posts: 25,487
|
Re: Square body Engine mounts
Quote:
Did you have to notch the frame rails? I read somewhere that the rails have to be cut back 3/8ths of an inch on both sides. LockDoc
__________________
Leon Locksmith, Specializing In Antique Trucks, Automobiles, & Motorcycles (My Dually Pickup Project Thread) http://67-72chevytrucks.com/vboard/s...d.php?t=829820 - |
|
![]() |
![]() |
![]() |
#8 |
Registered User
Join Date: Feb 2010
Location: rochelle il.
Posts: 356
|
Re: Square body Engine mounts
Doc mine bolted right in. A buddy of mine did the same mounts on a 69 c10. We will see in a couple weeks when i bolt the engine in if it sits good.
|
![]() |
![]() |
![]() |
Bookmarks |
|
|