|
|
|
04-25-2004, 12:58 PM
|
#1 |
|
Fabricate till you "puke"
Join Date: Jun 2002
Location: Ill
Posts: 9,403
|
73-87 crossmember ?
I have picked up a later crossmember to notch & drop the nose of the longhorn another 1" -1 1/4". From reading a few threads on the swap, I remember that a couple bolts dont line up on the 67-72's.....Can anybody tell me which ones , before its all apart? all the side holes will need to be redrilled after the notch, so my main focus is on the 3 bottom holes on ea side. Thanks, crazyL
__________________
69 longhorn,4" chop,3/5 drop, 1/2 ton suspension/disc brakes,1 1/2" body drop,steel tilt clip, 5.3/Edelbrock rpm intake/600 carb, Hooker streetrod shorties,2 1/2" exhaust/ H pipe/50's Flows , 6 spd Richmond trans,12 bolt/ 3.40 gears.... |
|
|
|
04-25-2004, 03:15 PM
|
#2 |
|
Registered User
Join Date: Apr 2001
Location: jefferson city, mo
Posts: 1,364
|
the three on the bottom of each side line up, its one of the bolts that go through the side that doesnt. Its really close though, i just ovaled the hole out a little and it fit.
|
|
|
|
|
04-25-2004, 03:37 PM
|
#3 |
|
Registered User
Join Date: Sep 2003
Location: Ohio
Posts: 127
|
the bottom holes okay it was the front side holes I ovaled out and I think it varies a little so you might get lucky and not have to because they were only a half hole off.
Last edited by bigskiohio; 04-25-2004 at 03:39 PM. |
|
|
|
|
04-25-2004, 03:43 PM
|
#4 |
|
Fabricate till you "puke"
Join Date: Jun 2002
Location: Ill
Posts: 9,403
|
thanks guys
__________________
69 longhorn,4" chop,3/5 drop, 1/2 ton suspension/disc brakes,1 1/2" body drop,steel tilt clip, 5.3/Edelbrock rpm intake/600 carb, Hooker streetrod shorties,2 1/2" exhaust/ H pipe/50's Flows , 6 spd Richmond trans,12 bolt/ 3.40 gears.... |
|
|
|
 |
| Bookmarks |
|
|
Hybrid Mode
