![]() |
Register or Log In To remove these advertisements. |
|
|
![]() |
|
Thread Tools | Display Modes |
|
![]() |
#1 |
Registered User
Join Date: Nov 2004
Location: Nebraska
Posts: 762
|
DANA 44 Front axle problem
Does anyone know if a dana 44 front axle has c-locks holding the axles in? If so, how do you remove the front axle. If not, will the axle just pull out? It doesn't have a lock screw holding the pinion shaft in, it is a roll pin, or what looks to be a roll pin. Has anyone pulled the axles out? Help needed!
|
![]() |
![]() |
![]() |
#2 |
Majician
Join Date: Nov 2004
Location: In the Middle
Posts: 329
|
The axleshafts are not held by c-clips as the rear axles are. To remove them you have to take off the hub/rotor assembly and then they just slide out.
|
![]() |
![]() |
![]() |
#3 |
huh ???
Join Date: Nov 2002
Location: Fredericksburg,Va.
Posts: 3,368
|
Don't forget to remove the spindle...
__________________
90 Blazer Silverado 350w/ 700R4 and 32" Kelly's "I am a bomb technician. If you see me running try to keep up!" |
![]() |
![]() |
![]() |
#4 |
Majician
Join Date: Nov 2004
Location: In the Middle
Posts: 329
|
Yep, I forgot to mention the spindle. The spindle can be a PITA to remove. I have a slide hammer type puller that I use to pull it off. AutoZone may rent the pullers.
|
![]() |
![]() |
![]() |
Bookmarks |
|
|