|
|
|
04-06-2005, 04:46 PM
|
#1 |
|
Registered User
Join Date: Sep 2003
Location: New Salem, ND
Posts: 1,558
|
383 clearance pics
I would like to see some pics of the bottom end of a 383 that has been clearanced. I was wondering how much metal I would have to take out.
__________________
07 Chevy classic LBZ Duramax (a few mods) '67 Chevy 1/2 ton 2wd (in pieces) '69 Chevy 1/2 ton 2wd (on hold) '71 GMC 3/4 ton 4x4 ‘71 GMC 1/2 ton 2wd suburban |
|
|
|
04-07-2005, 07:09 PM
|
#2 |
|
my gas saver
Join Date: Sep 2003
Location: Clarksville, TN
Posts: 2,046
|
we built a 383 about 3 years ago and if i remember right, we only had to remove a bit of the block on the very back bottom edge where the oil filter is. i'll try to dig some pics up.
EDIT: now that i'm remembering a little more i think a bit had to be taken from the bottoms of the cyl. walls, but the machine shop did that part so i have no clue of how much it was.
__________________
85' SWB, 4.3/TH350, getting ready for paint 84`SWB, 462ci./TH400, cowl hood, 15" billet spec., flows, blazer buckets/console, flat black 71`SWB, project ebay feedback Last edited by CHEVYE; 04-07-2005 at 07:12 PM. |
|
|
|
|
04-07-2005, 07:32 PM
|
#3 |
|
my gas saver
Join Date: Sep 2003
Location: Clarksville, TN
Posts: 2,046
|
here's some from the net.
__________________
85' SWB, 4.3/TH350, getting ready for paint 84`SWB, 462ci./TH400, cowl hood, 15" billet spec., flows, blazer buckets/console, flat black 71`SWB, project ebay feedback |
|
|
|
 |
| Bookmarks |
|
|
Hybrid Mode
