|
|
|
04-06-2005, 07:42 PM
|
#1 |
|
18 Till I Die
Join Date: Mar 2005
Location: Alberta, Canada
Posts: 1,522
|
69 Big Block Towers
Anyone know why the holes in the towers are so large? and can you take out the 2 piece driveshaft and install a 1 piece. Does anyone make a conversion ?
Last edited by kelsfine69; 04-06-2005 at 07:48 PM. |
|
|
|
04-06-2005, 08:23 PM
|
#2 |
|
Registered User
Join Date: Jun 2003
Location: Napa, Ca.
Posts: 103
|
Large Hole in Big Block motor mounts
The hole is large because the motor mount is 2 piece. The part that bolts to the block is similar to small block mount except it has a threaded hole right in the middle of it. There is a smaller mount that goes on the other side of the steel bracket & I believe it has a steel sleeve in it that passes through that big hole & up against the other half of mount. Then there is a large bolt that that bolts the whole works together sandwiching the steel frame bracket in between. I hope this is clear enough.
Rick-Ca. |
|
|
|
|
04-06-2005, 09:49 PM
|
#3 |
|
18 Till I Die
Join Date: Mar 2005
Location: Alberta, Canada
Posts: 1,522
|
Can anyone send me a parts pic diagram? or where I can buy this inner mount and bolt
Last edited by kelsfine69; 04-08-2005 at 12:19 AM. |
|
|
|
 |
| Bookmarks |
|
|
Hybrid Mode
