upper A arm bushing? - The 1947 - Present Chevrolet & GMC Truck Message Board Network

brad juan · 05-09-2005, 10:17 PM

how do the upper a arm bushings come apart on my 72 1/2 ton. are the ends pressed or screwed in?

4tiresngas · 05-09-2005, 11:38 PM

I assume 67-72 bushings are the same, but don't qiote me. Anyhow, my '69 bushings were screw in. I think it was a 1 3/8" socket that fit the ends. I just put them in a vise and used a 3/4 drive ratchet and a piece of pipe. Was not too hard.

brad juan · 05-10-2005, 02:11 PM

Thanks, I also just noticed I put this in the wrong forum, I was wondering why I could not find it !!!

05-09-2005, 10:17 PM	#1
brad juan Registered User Join Date: Mar 2005 Location: Chico, CA Posts: 42	upper A arm bushing? how do the upper a arm bushings come apart on my 72 1/2 ton. are the ends pressed or screwed in? __________________ 1972 chevy C/10, with factory air, SWB, 350,700r4, lowered 3 and 5.

05-09-2005, 11:38 PM	#2
4tiresngas An American Soldier Join Date: Feb 2005 Location: Grumolo D' Abadessee, Italy Posts: 503	I assume 67-72 bushings are the same, but don't qiote me. Anyhow, my '69 bushings were screw in. I think it was a 1 3/8" socket that fit the ends. I just put them in a vise and used a 3/4 drive ratchet and a piece of pipe. Was not too hard. __________________ Dan dan.brue@us.army.mil

05-10-2005, 02:11 PM	#3
brad juan Registered User Join Date: Mar 2005 Location: Chico, CA Posts: 42	Thanks, I also just noticed I put this in the wrong forum, I was wondering why I could not find it !!! __________________ 1972 chevy C/10, with factory air, SWB, 350,700r4, lowered 3 and 5.



Register or Log In To remove these advertisements.

Register or Log In To remove these advertisements.