|
|
|
06-02-2005, 08:54 PM
|
#1 |
|
ran out of money
Join Date: Apr 2003
Location: northern, NJ
Posts: 925
|
frame differences?
i was wondering if a 1964 chevy truck frame would be able to unbolt and bolt onto say like a 71 chevy truck? i guess my main question is are the frames interchangeable? even the body mounts?
Thank you Rat
__________________
Modify everything, leave nothing alone!~  
|
|
|
|
06-02-2005, 09:04 PM
|
#2 |
|
its all about the +6 inches
Join Date: Jan 2001
Location: Hilliard Ohio
Posts: 2,690
|
I'm going off a 3 year old memory here, but I think some one on here said they were real close, but not a direct bolt in.
|
|
|
|
|
06-02-2005, 09:13 PM
|
#3 |
|
Got Light Emitting Diode?
Join Date: Apr 2004
Location: Newberg, OR
Posts: 2,485
|
not to hijack but would the PS mod be like the 67 where you have to make the dimple or are the boxes different
__________________
1968 1/2 ton 2wd lwb 6 lug disc and bags up front. Next c notch and rear bags '02 Chevy Silverado LT ext cab short bed 2WD 5/7 drop on 22's  (the family car)1993 Cherokee work ride/weekend wheeler |
|
|
|
|
06-02-2005, 09:18 PM
|
#4 |
|
ran out of money
Join Date: Apr 2003
Location: northern, NJ
Posts: 925
|
would a 67 to a 71 be a dirrect fit then?
anyone else? Rat
__________________
Modify everything, leave nothing alone!~
|
|
|
|
|
06-02-2005, 09:31 PM
|
#5 |
|
its all about the +6 inches
Join Date: Jan 2001
Location: Hilliard Ohio
Posts: 2,690
|
The only difference on a bare frome on a 67 to a 71, would be the dimple for the power steering box would be present on the later one, and also, the 67 doesn't have provisions for a big block. I know there is a spot on the forward passenger rail that is flaired up, that is for big block fuel pump room...
That is all that would be different to my knowledge. |
|
|
|
|
06-03-2005, 02:30 AM
|
#6 |
|
Senior Member
  
Join Date: Jan 2005
Location: CA
Posts: 5,982
|
There is less clearance for the engine between the frame rails on a 67. The frame rails are wider. This causes problems when installing headers.
I had a SWB 67 and it had the dimple from the factory for the power steering pump. |
|
|
|
|
06-03-2005, 08:17 PM
|
#7 |
|
ran out of money
Join Date: Apr 2003
Location: northern, NJ
Posts: 925
|
ok thanks, is there a problem with putting a big block into a 67's frame though? i am not worried about headers since it will be fender headers going into it.......
Also power steering dimple doesnt matter, not going to use power steering Thanks everyone for the help Rat
__________________
Modify everything, leave nothing alone!~
|
|
|
|
 |
| Bookmarks |
|
|
Hybrid Mode
