88 Burb, runs rough at start, gets worse - The 1947 - Present Chevrolet & GMC Truck Message Board Network

kw · 06-10-2005, 01:03 PM

Hey all,

I'm trying to troubleshoot a problem I'm having with my 88 GMC suburban.

When it starts, the idle is rough, when I start to drive it sometimes backfires, but runs rough and seems to lack power. If I romp on the gas it seems to get up and go OK, but when at around 45-55 mph it seems to hesitate and run rough. I checked the plugs and they seem OK. Thinking it might be water in the fuel, I've been running drygas and fuel injection cleaner every tank and still it does it.

I don't have a shop manual for it yet, and was wondring if there is a systematic approach to repair this without replacing every sensor in the vehicle. Any ideas?

The engine is fuel injected and stock. 94k miles.

I was going to start with the fuel filter. Where is it located?

Thanks in advance for any help.

Kurt

86 GMG · 06-10-2005, 03:28 PM

fuel filter will be located some were on the passenger side frame rail about mid-way back
if anyone else can direct him more accuratly please do the filter wile look like a pop can cut in half (best lamons term i could think of) sorry it may have a protective plate or panel covering it from any road harm
best of luck

f.monroe · 06-11-2005, 12:17 AM

If it isnt kicking up a Check Engine code I would try a new set of plug wires . If it is kicking a code most Auto part stores will scan it for free . Frank

06-10-2005, 01:03 PM	#1
kw Registered User Join Date: Jul 2000 Location: Owings, MD Posts: 119	88 Burb, runs rough at start, gets worse Hey all, I'm trying to troubleshoot a problem I'm having with my 88 GMC suburban. When it starts, the idle is rough, when I start to drive it sometimes backfires, but runs rough and seems to lack power. If I romp on the gas it seems to get up and go OK, but when at around 45-55 mph it seems to hesitate and run rough. I checked the plugs and they seem OK. Thinking it might be water in the fuel, I've been running drygas and fuel injection cleaner every tank and still it does it. I don't have a shop manual for it yet, and was wondring if there is a systematic approach to repair this without replacing every sensor in the vehicle. Any ideas? The engine is fuel injected and stock. 94k miles. I was going to start with the fuel filter. Where is it located? Thanks in advance for any help. Kurt

06-10-2005, 03:28 PM	#2
86 GMG Registered User Join Date: Apr 2005 Location: Tulsa Oklahoma Posts: 943	fuel filter will be located some were on the passenger side frame rail about mid-way back if anyone else can direct him more accuratly please do the filter wile look like a pop can cut in half (best lamons term i could think of) sorry it may have a protective plate or panel covering it from any road harm best of luck __________________ square body trucks an addiction or an investment either way they consume all my extra time and money

06-11-2005, 12:17 AM	#3
f.monroe Senior Member Join Date: May 2004 Location: Caldwell,Tx. Posts: 3,648	If it isnt kicking up a Check Engine code I would try a new set of plug wires . If it is kicking a code most Auto part stores will scan it for free . Frank



Register or Log In To remove these advertisements.

Register or Log In To remove these advertisements.