|
|
|
02-04-2006, 09:13 AM
|
#1 |
|
still buypickupparts
Join Date: Sep 2003
Location: charlotte
Posts: 637
|
round two A/C parts
Is there any way to test a/c parts that are stored in the attic?. like the Accumilator?evaporator? and the A/c hose assembly?. I have these up in the attic and I'm wondering are they any good how do you test them on the bench. or are they taking up space on shelf #4. or do they need to go to scrap?
__________________
Its Gonna be a Great Day, I woke up this Morning. 72 SWB Fleetside freshly painted. putting a 94 LT1 with 700R4 tranny lowered 4 in the front 6 in the back 81 chevy half ton 350 89 Silverado 4x4 going ta church truck |
|
|
|
02-04-2006, 09:24 AM
|
#2 |
|
Registered User
Join Date: Sep 2005
Location: Smith Mountain Lake Virginia
Posts: 1,537
|
Re: round two A/C parts
about the only test you can do would be a pressure test for leaks - but for the most part, you have to have the whole system together that's when you usually start looking for leaks too - and thats by putting the system into a vacuum and waiting to see if it holds. I wouldn't scrap any of it - unless(until) someone tries to use a part and it's determined to be bad.
__________________
"A cat will almost always blink when hit between the eyes with a ball peen hammer" (you don't always have to state the obvious) Wear your PPE! You can eat with false teeth but you can't see with a false eye. 1959 Studebaker Silverhawk 350/400 1972 C10 L6 3OTT 2005 F350 - Built - whew! |
|
|
|
|
02-04-2006, 11:56 AM
|
#3 |
|
Registered User
Join Date: May 2000
Location: Petrolia,Ontario,Canada but working in Port Huron,Mi.
Posts: 1,771
|
Re: round two A/C parts
If you could properly seal the inlet and outlet of the various parts you can use compressed air to test them.
Or(a little safer)would be a vacume leakdown test. If you can obtain a vacume pump and a gauge.Pull a vacume and then let said part sit.If it holds vacume it "should" be o.k. Also depends on how old those parts are.Rubber will deteriorate with time,heat and UV exposure.
__________________
71 blazer,350SBC,approx.375HP,700R4,factory GM TPI.Dual electric fans,33x12.5x15 ATR on stock suspension. Petrolia,Ontario,Canada but working in Port Huron,MI. See ALL my Blazer pic's HERE |
|
|
|
|
02-04-2006, 01:11 PM
|
#4 |
|
Registered User
Join Date: Dec 2003
Location: Stockton, CA
Posts: 1,579
|
Re: round two A/C parts
If the parts have not been sealed I would not use any of them. You can take the parts to a radiator shop and the can pressure test all of them for you.
__________________
For every person with a spark of genius, There are a hundred with ignition trouble.  70 Short/Step
|
|
|
|
 |
| Bookmarks |
|
|
Hybrid Mode
