![]() |
|
![]() |
#1 |
Registered User
Join Date: Jan 2006
Location: GREEN BAY,WI
Posts: 91
|
Wrong ball joints?
I bought new lowering spindles for my 72 from GMCPAUL'S and was installing them last night. I put in new upper and lower ball joints while I was doing the job. I had the spindle in place,and was torquing down the upper ball joint but can't get it tight enough to see the hole for the cotter pin to go through. I can't get it tightened down enough it seems.The I looked at the other new one I have for the other side and its identical. I put the rest of it together and went to the other side,same thing on the other side too.
Anybody run into this problem? I called the parts place and they verified that they gave me the correct ones. Any thoughts,ideas would be appreciated. Thanks, Andy |
![]() |
![]() |
![]() |
#2 |
Registered User
Join Date: May 2001
Location: Benbrook, TX
Posts: 1,060
|
Re: Wrong ball joints?
Try the old spindle on the new ball joint. You may have the wrong year new spindles.
__________________
69 swb stepside, rebuild and upgrade in progress |
![]() |
![]() |
![]() |
#3 |
Registered User
Join Date: Feb 2004
Location: WHITEVILLE N.C.
Posts: 494
|
Re: Wrong ball joints?
some spindles are for 73 & up trucks and require ball joints from these years. Mine did but I can't remember if it was the bottom or the top joint.
__________________
72 CHEYENNE 10 SUPER 468/400/3.73 |
![]() |
![]() |
![]() |
#4 |
Senior Member
![]() Join Date: Feb 2004
Location: Williamsburg, Ohio
Posts: 1,783
|
Re: Wrong ball joints?
I believe the correct upper for a 71-72 spindle is a Moog K6124. Lower is K6117,
|
![]() |
![]() |
![]() |
Bookmarks |
|
|