Register or Log In To remove these advertisements. |
|
|
|
Thread Tools | Display Modes |
|
05-02-2006, 07:34 PM | #1 |
Registered User
Join Date: Jul 2005
Location: downingtown pa
Posts: 62
|
where do i put the wires
i just swaped out the 6 for a 8 how do i make the 6cyl wires go into the hei on my 8 what wire goes where
|
05-02-2006, 07:43 PM | #2 |
71 GMC 454/TH400
Join Date: Dec 2005
Location: Blue Mound TX
Posts: 214
|
Re: where do i put the wires
Be more specific, plug wires? Start/Ignition switch wires? If you are reffering to the hot wire for the HEI you will have to make a new one that is from a keyed 12v source. The starter wire(s) should be the same, but you will just use the one to the solenoid since you are no longer running points.
__________________
"The bigger you are the harder you fall, the farther you walk the longer you crawl." |
05-03-2006, 08:35 PM | #3 |
Registered User
Join Date: Feb 2004
Location: Idaho
Posts: 4,033
|
Re: where do i put the wires
Check the FAQ's there was a post of a colored wiring diagram, I don;t know them off the top of my head. Hope you get it running
__________________
"Remember, They can Kill You, but they can't eat You, That's against the law!!!!!!!!!" |
Bookmarks |
|
|