|
Register or Log In To remove these advertisements. |
|
|
|
|||||||
 |
|
|
Thread Tools | Display Modes |
|
|
09-04-2006, 02:41 PM
|
#1 |
|
YA YA
Join Date: Aug 2004
Location: Rockledge, Fl
Posts: 1,273
|
Exhaust Manifold installation ?
The manual that I have reflects that the ramhorns should be torqued down to 35 ft lbs. That didn't seem very tight to me, is it correct? 30 ft. lbs wasn't really even enough to collapse the lock washer. On a different note - I definitely have to recommend POR-15 exhaust paint. They turned out looking great, though the real test will be if it burns off or not.
__________________
Jimbo '72 SWB - 350 (frame-off resto in progress - donations accepted) '04 Chevy Avalanche '03 Cadillac CTS (wife's ride) Restoration progress - http://67-72chevytrucks.com/vboard/s...d.php?t=335707 |
|
|
|
09-04-2006, 06:49 PM
|
#2 |
|
its all about the +6 inches
Join Date: Jan 2001
Location: Hilliard Ohio
Posts: 2,690
|
Re: Exhaust Manifold installation ?
there is no need to torque them down real tight.
Honestly, I would never even bother with a torque wrench either. Just grab a 3/8 impact and zim them on. Been doing this all my life and NEVER had a problem. |
|
|
|
|
09-04-2006, 07:17 PM
|
#3 |
|
YA YA
Join Date: Aug 2004
Location: Rockledge, Fl
Posts: 1,273
|
Re: Exhaust Manifold installation ?
Thanks Longhorn - that's just what I'll do.
__________________
Jimbo '72 SWB - 350 (frame-off resto in progress - donations accepted) '04 Chevy Avalanche '03 Cadillac CTS (wife's ride) Restoration progress - http://67-72chevytrucks.com/vboard/s...d.php?t=335707 |
|
|
|
|
09-04-2006, 09:59 PM
|
#4 |
|
Rottenwood Garage Member
Join Date: May 2005
Location: Marietta, Georgia
Posts: 4,321
|
Re: Exhaust Manifold installation ?
Remember...they WILL loosen up after some time (heating up and cooling down) so re-check them....as with all you hardware you can get to.
|
|
|
|
|
| Bookmarks |
|
|
Hybrid Mode
