|
|
|
10-15-2006, 10:01 PM
|
#1 |
|
Out of money
Join Date: Oct 2006
Location: Clinton, TN
Posts: 65
|
Time To Rebuild
I was going to replace my valve cover gaskets today to stop the oil leak. Well I got them off and decided to take my intake off and have it bead blasted. Well i got that off and looked under it and dug out this junk from the corner that really kind of worried me. I then decided to just rebuild the whole thing. Funny how a small project can turn into something big. I finally got the casting number for my heads and block. looks like the PO got a 70-76 block and put on a set of 67-68 291 double humps. My question is what sould I do to the heads to give a little more power while I got them off? Also any more performance advice would be appreciated. I know some will say go with a set of Vortecs but I am having to round up the money myself. The wife is not to happy when I tell her I have to put more money into my truck.
Last edited by trlrider77; 10-15-2006 at 10:01 PM. |
|
|
|
10-15-2006, 11:18 PM
|
#2 |
|
Registered User
Join Date: Jun 2002
Location: Knoxville Tenn.
Posts: 3,058
|
Re: Time To Rebuild
Best thing is to have a 3 angle valve job done on the seats. These are good street heads. (GM used them on the 302cid and other motors up to 350hp)
__________________
56 Chevy Bel-Air 2dr. HT (purchased new) 71 Chevy Cheyenne SWB PU (502HO) 65 GMC short bed step--work in progress and my gofer |
|
|
|
 |
| Bookmarks |
|
|
Hybrid Mode
