Cleaning up lots of parts FS

[byrd]

I am cleaning out and getting rid of the stuff I don't need and aren't going to use. I will post a pic or two for now and it you want to see something specifically just ask and I will get close up of what you want to see.REPLY ONLY herein the thread NO PM's to keep it all in the open and fair. I prefer paypal but will accept a US postal MO. Thanks...Randy


List of parts
1) battery tray, have some minor pitting and one little spot of rust on the
front left corner, not seen when installed.. $25 shipped
2)7 blade clutch fan 17.5" diameter condition unknown $35 shipped SOLD
3)5 blade clutchfan has one bent blade,but should be able to fix $15 shipped
4) brake booster and m/c combo with mounting brackets and one other braket, no prop vavle, conditoin unknown $25 plus ship
5)fram mount exhaust hanger? $10 shipped
6)2- wiper motors condition unknown $10 shipped/each
7)2 voltage reg both worked well when pulled $7 shipped/each
8)speaker braket $7 shipped
9)starter for sbc condtion unknown, was on a daily driver that caught fire
but didn't get the starter hot, should be ok, but assume it's a core, $10 plus ship
10) oil pump and rod, worked good when removed $15 shipped
11)black sunvisors pair driver shape with rods $25 shipped SOLD
12) NIP non tilt turn signal lever and knob $10 shipped
13)2' 5/16 fuel line with 4 clamps $8 shipped
14)sbc v-8 engine stands good condition $25 shipped
15) 2 sets of lower shock mounts for coil spring rears, one has been cleaned and painted with eastwoods two part converter, rust encapsulator, and high gloss chassis black $25 shipped, the other pair is original untouched $15 shipped sold
16)2 power sterring pumps, both with one bracket, one missing cap, condition unknown $25 shipped/each
17)bracket in middle unknown? $5 shipped
18)2 partial door latches, with inned and outer plater and bolts, no shims $10 shipped
19)5 glove box doors in fair condition,2 67-8 style, $10 shipped/each or deal formore than one.
20)2 pieces of original GM rocker panels, they have been cut and drilled out to get to the inners.(see pics, they are not complete) They are nice and solid and could be used to patch up some spots in your rockers, $30 shipped for the pair.
21)1 set of 3:73 gears stamped 11:41 with open carrier , ring and pinion, and all associated parts out of a 6 lug 12 bolt rear,in good condition. The gears are in good condition show little wear. All bearings, spiders gears, pin,shims, bolts, ect... I just took out everything out of the rear end and put it in a bucket to keep it all together.
Theses came out of Frank and would be great for a driver $40 plus ship
22) set #2 3:73 gears stamped 11:41,open carrier same thing as above, I took everything out of the rear end and put it in a bucket to keep it all together. This set of gears has some small spots of light surface rust, but look descent overall, this set also came from a 6 lug 12 bolt rear.$20 plus ship
23)67-8 non tilt auto column with shaft, has good fiber optic, but needs new idicator, wiring is good, levers and wheel are junk, $20 plus ship, wheel is free with column if wnated $12 extra to ship.
24) non tilt auto column, in good condition, has good fiber optic, needs indicator, levers are ok for driver, wiring is good, wheel and the shaft are not included $30 plus shipping.
25) steering wheel w cheverolet wrote on it, 4 spoke off 88-93 something, nice and tight not all chewed up and loose, $50 plus ship FIRM
26) heater control with broken fan control lever, rough looking but sound could be restored easily with a kit, cables are junk and not included $10 shipped.
All prices OBO...Thanks

[byrd]

more pics

[byrd]

a few more...

[byrd]

couple more

[badpeanut]

Is the black "Chevrolet" horn button on the late model steering wheel for sale?

[byrd]

no the wheel is for sale and the button goes with it

[BAD4X4]

Are the visors in good shape on both sides, no tears and etc? If they are in good shape I will take them. Thanx Dana

[rage'nrat638]

i will take the 7 blade fan and do you take pay pal ? thanks mark
p.m. me the info please.

[byrd]

Originally Posted by rage'nrat638

i will take the 7 blade fan and do you take pay pal ? thanks mark
p.m. me the info please.

PM ON THE way, yes on paypal...Randy

[rage'nrat638]

cash sent thanks buddy

[byrd]

Originally Posted by BAD4X4

Are the visors in good shape on both sides, no tears and etc? If they are in good shape I will take them. Thanx Dana

Just checked them again, no cuts tears, bad spots, just dirty...
I will PM you payment info...Randy

[67BABYBLUE]

I'll take the pair of untouched lower shock mounts for coil spring rears for $15 shipped. Please PM your info. Thanks

[byrd]

Originally Posted by 67BABYBLUE

I'll take the pair of untouched lower shock mounts for coil spring rears for $15 shipped. Please PM your info. Thanks

PM sent

[BAD4X4]

cash just sent for visors...thanks
Dana

[ScottH]

Can you get me a total price on #22 for just the ring and pinion gear to 08753?

Thanks.

[BIG ORANGE]

What yr model is the powerbrake booster setup and does the rod that runs to the brake pedal come with it, didnt see it in pic.
thanks Big O.

[byrd]

Originally Posted by BIG ORANGE

What yr model is the powerbrake booster setup and does the rod that runs to the brake pedal come with it, didnt see it in pic.
thanks Big O.

It came off a 72 and no the pedal rod is not with, but I believe I may have it. If I have it I will throw it in, I will check and LYK.

[byrd]

Originally Posted by BIG ORANGE

What yr model is the powerbrake booster setup and does the rod that runs to the brake pedal come with it, didnt see it in pic.
thanks Big O.

Haven't been able to find it..

[byrd]

Originally Posted by ScottH

Can you get me a total price on #22 for just the ring and pinion gear to 08753?

Thanks.

I will check on it and LYK

[byrd]

bab4x4,ragenrat,67babyblue
Your stuff is going out in the morning. Thanks!!

ScottH, how does $40 shipped sound?

[jaros44sr]

I'm interested in the speaker bracket, where does it mount, in the top of the dash or under the heater control panel? J

[byrd]

Originally Posted by jaros44

I'm interested in the speaker bracket, where does it mount, in the top of the dash or under the heater control panel? J

This one is for the top of the dash between the defrost vents.

[jaros44sr]

Originally Posted by byrd

This one is for the top of the dash between the defrost vents.

Thanks Byrd for gettin back to me, but I don't have the time to cut up my dash right now.

[Sams68C10]

Do you still have the brake booster? If so, do you know if it will fit a 68 C10, I measured the firewall mount and the bolts from top to bottom are 2 3/4 and from side to side 3 1/2. And what would it cost for shipping to Okla. 74447?

Thanks,

Sam

[byrd]

What hasen't sold will be going up on ebay shortly.
Thanks,
Randy