|
Register or Log In To remove these advertisements. |
|
|
|
|||||||
 |
|
|
Thread Tools | Display Modes |
|
|
05-02-2007, 10:13 PM
|
#1 |
|
Registered User
Join Date: Apr 2007
Location: midstate upstate N.Y.
Posts: 10
|
stepside fender patch panels
Anyone know of a source for stepside lower front repair patches?I don't think they're available,but what they hey it can't hurt to ask.Anyone have ideas on fabrication without a shrinker-stretcher?Any help info appreciated,Thanks to all
|
|
|
|
05-02-2007, 11:45 PM
|
#2 |
|
Granddad's Ol' Truck
Join Date: Jan 2005
Location: MS
Posts: 588
|
Re: stepside fender patch panels
Never have seen the patch panels. Only the complete fenders by CounterParts and the actual step panels themselves. Several different companies make the replacement bed sides (with or without stake pockets).
__________________
1971 Chevrolet Custom 10 short step-side 2005 GMC Sierra SLT 2500HD crew cab 2wd [I]1971 Chevrolet Custom 10 Deluxe lwb fleet-side |
|
|
|
|
05-02-2007, 11:56 PM
|
#3 |
|
Registered User
Join Date: Aug 2006
Location: Bakersfield,CA
Posts: 7,893
|
Re: stepside fender patch panels
if youre any good at fab work you should be able to do it just fine with some sheet metal
__________________
-steven Alte Seele S.S. "Allison" '72 C/10 LWB 350SB/TH350 - DD PITBULL IS NOT A CRIME |
|
|
|
|
05-03-2007, 11:53 AM
|
#4 |
|
Registered User
Join Date: Aug 2005
Location: Pasadena,Tx /Pto Pta DR
Posts: 5,415
|
Re: stepside fender patch panels
No one makes them as far as I know. I just use sheetmetal if its not bad and if it is a large hole just cut one off a scrap fender. They don't go for much money usually unless really nice condition. The Counterpart fenders are ok but need alot of body work to make them look good. They flare up too much at the point where they attach to the bedside.
|
|
|
|
|
05-03-2007, 11:59 AM
|
#5 |
|
Registered User
Join Date: Nov 2006
Location: Springfield/Kansas City
Posts: 1,842
|
Re: stepside fender patch panels
I repaired both of my fenders with a set of shears, sheet metal, and a welder.
Just make your own patch panel. |
|
|
|
|
| Bookmarks |
|
|
Hybrid Mode
