|
Register or Log In To remove these advertisements. |
|
|
|
|||||||
 |
|
|
Thread Tools | Display Modes |
|
|
09-14-2002, 08:24 AM
|
#1 |
|
67-72 Addict!
Join Date: Feb 2002
Location: The TAX State!
Posts: 7,856
|
Replacing Upper Steering Column Bearing
Does this upper bearing pop out with a screwdriver?. My steering wheel has alot of play and I want to replace it. Thanks
__________________
Jim 1970 C/10 Fleetside w/Ghost Flames Lowered 4.5" front and 4" rear (Raked) 355/350 Turbo w/shift kit 10" Redneck Performance Verter w/2500 stall Hooker Super Comps part#2808-1 Performer RPM Air-Gap 12 Bolt w/3:73 gears- Eaton Posi Comp Cams XE262 with 1.6 Crane Energizers, Road Demon 625 and Brodix IK 180 heads |
|
|
|
09-14-2002, 10:39 AM
|
#2 |
|
Careful, they attack...
Join Date: Aug 2001
Location: Waterford, MI, USA
Posts: 1,107
|
Should just come right out... hehe. Mine did when I replaced it. Just kinda got to pry it out and it should come.
|
|
|
|
|
09-14-2002, 11:05 AM
|
#3 |
|
Registered User
Join Date: Nov 2001
Location: Fairmont WV
Posts: 304
|
I should just slide out. I used a small hooked scribe to slide it out. BTW I thought mine was wore out, but the steering wheel just was not tight. The bearing is tapered and the more you tighten the nut behind the wheel the tighter it gets. So if you have had the wheel off recently, you may have the old "Loose nut behide the wheel problem.
__________________
Rod Childers '71 C10 Stepside |
|
|
|
|
| Bookmarks |
|
|
Hybrid Mode
