uuum i dont think this is good (clutch question) - The 1947 - Present Chevrolet & GMC Truck Message Board Network

Blue_71 · 09-21-2002, 09:15 PM

i disconnected all the clutch linkages when i rebuilt the top end in my 4x4, and tonight when i hooked it back up, i can push in the clutch and it doesnt want to come back up. both springs are on and strong... the throw out fork can move side to side though (towards frame and towards pilot shaft) im thinkign either the throw out fork or bearing is bad.. i know i cant replace the bearing without taking out either the tranny or motor, but is it at all possible to replace the fork without taking tranny/motor out?

cableguy0 · 09-22-2002, 12:08 AM

im pretty sure the clutch fork is trapped by design in the bellhousing.im almost positive u have to pull the tranny out to do it.someone please correct me if im wrong

Blue_71 · 09-22-2002, 12:13 AM

that sucks... i was afriad of that... ill wait untill i get the truck ready to start again and see if it works....

09-22-2002, 12:08 AM	#2
cableguy0 Senior Member Join Date: Apr 2000 Location: Delta,Pa Posts: 14,948	im pretty sure the clutch fork is trapped by design in the bellhousing.im almost positive u have to pull the tranny out to do it.someone please correct me if im wrong __________________ Owner of North Point Car Care in Dundalk Md. We specialize in custom exhaust on both modern and classic vehicles. We are a full service auto shop from classics to modern vehicles. Feel free to contact me with questions. I will give a 10% discount to any board member.



Register or Log In To remove these advertisements.

Register or Log In To remove these advertisements.