|
|
|
10-05-2007, 02:30 AM
|
#1 |
|
Registered User
Join Date: Sep 2003
Location: Boise ID
Posts: 609
|
Dart Allum Heads
Looking into running Dart Pro One angle plug heads. What would be A good set of headers to run with angle plug heads??
__________________
"72" Red CORVETTE 4-speed 350 "70" Chevy Short Bed early stages of resto. Edel 600 cfm carb Weiand Stealth Intake HEI shorty Headers 4/2 Drop 295 50R 15 TOYO on 10 inch wide corvette rally rims at all 4 corners. "CHEVY RULES" 
|
|
|
|
10-05-2007, 02:11 PM
|
#2 |
|
Registered User
 Join Date: Nov 2006
Location: KINGSPORT,TN.
Posts: 3,035
|
Re: Dart Allum Heads
I,VE GOT a set of those heads myself and they will except any standard or big tube chevy header. tube size is determined by the compression of the engine and cu. inch. i,am going to be almost 11-1 compression myself.
bob
__________________
I BELIEVE IN JOHN 3:16 |
|
|
|
|
10-05-2007, 02:46 PM
|
#3 |
|
Registered User
Join Date: Feb 2007
Location: Tucson,AZ
Posts: 66
|
Re: Dart Allum Heads
I am running a set of Pro1, 180cc, 64cc chamber heads on my TPI motor in my truck but they are straight plug. I personally think the angle plug design isn't any better or worse than straight plug. But with the straight plug design, your worries about clearance issues aren't there.
Sorry I could answer your question but you bought a set of good heads. Hopefully you planned out your compression ratio to account for the aluminum heads.
__________________
1970 C10 SWB, 67 front clip, 3/5 drop, 350 TPI/700R4, Fiberglass tonneau cover, lots of body mods and.....a ford seat |
|
|
|
 |
| Bookmarks |
|
|
Hybrid Mode
