|
|
|
11-07-2007, 02:44 PM
|
#1 |
|
Registered User
Join Date: Mar 2006
Location: Northern VA\Raleigh NC
Posts: 56
|
Is it possible?
Is it possible to remove the bed header panel without disassembling the bed? This is for a fleetside steel floor.
|
|
|
|
11-07-2007, 02:52 PM
|
#2 |
|
More Cowbell....
Join Date: Mar 2004
Location: Puckett, MS
Posts: 3,569
|
Re: Is it possible?
If your torch tanks are full....YES. (Fire in the hole)
__________________
There once was a member from Puckett.....Who ( fill in the blank blank blank ) bucket |
|
|
|
|
11-07-2007, 04:23 PM
|
#3 |
|
WTB this ad
Join Date: Sep 2004
Location: Lafayette Georgia
Posts: 5,074
|
Re: Is it possible?
If the bed is off the truck it should come right off. No torch required
 .
|
|
|
|
|
11-07-2007, 04:45 PM
|
#4 |
|
Senior Member
Join Date: Jan 2003
Location: daytonabeach
Posts: 22,956
|
Re: Is it possible?
i've replaced a couple by un bolting the floor back to the wheel tubs to get enough flex in the sides to get the front panel out and the new one in whitout doing any damage to any of the components
__________________
71c-10 350/2004r/4:11 lowered3/4 longbed/dead by hurricane MEANING OF DEATH::::: SOMEBODY ELSE GETS YOUR STUFF DONT BELIEVE EVERYTHING YOU THINK TAKE MY ADVISE;I DON'T USE IT ANYWAY |
|
|
|
|
11-08-2007, 07:27 AM
|
#5 | |
|
Registered User
Join Date: Mar 2006
Location: Northern VA\Raleigh NC
Posts: 56
|
Re: Is it possible?
Quote:
|
|
|
|
|
 |
| Bookmarks |
|
|
Hybrid Mode
