|
Register or Log In To remove these advertisements. |
|
|
|
|||||||
 |
|
|
Thread Tools | Display Modes |
|
|
09-09-2008, 09:37 PM
|
#1 |
|
Registered User
Join Date: Jul 2008
Location: Tracy Ca
Posts: 171
|
water temp sending unit
Removed my 350 from 72 K-10. I noticed that there are two sending units in the heads one located by the #1 cyclinder and one by # 8 cyclinder. Are these water temp? and if so can I use the port located in my Edelbroke intake maniforld instead??
|
|
|
|
09-09-2008, 10:29 PM
|
#2 |
|
its all about the +6 inches
Join Date: Jan 2001
Location: Hilliard Ohio
Posts: 2,693
|
Re: water temp sending unit
They6 are both temperature sending units, yes. The drivers one for the guage or dummy light, the passenger side one for a smog control vac advance lock out.
You can put one in the intake, but you're better off keeping tabs on the heads. They are what gets dammaged when it gets hot. |
|
|
|
|
09-10-2008, 04:25 PM
|
#3 |
|
Registered User
Join Date: Jul 2008
Location: Tracy Ca
Posts: 171
|
Re: water temp sending unit
I think I will leave them where they are. Thanks Longhorn for the info and response
|
|
|
|
|
09-10-2008, 04:39 PM
|
#4 |
|
Registered User
Join Date: Sep 2005
Location: Villa Rica Ga
Posts: 889
|
Re: water temp sending unit
yeah better to use the ones n the heads, i just put a plug in my intake to seal it off. looks better that way anyways, dont have that goofy coiled wire runn on the top of your engine , looks ICKEY! haha
|
|
|
|
|
| Bookmarks |
|
|
Hybrid Mode
