Register or Log In To remove these advertisements. |
|
|
|
Thread Tools | Display Modes |
|
12-09-2008, 10:32 AM | #1 |
Registered User
Join Date: Nov 2007
Location: Franklin Indiana
Posts: 635
|
Serpentine Swap Questions
I understand that you can use the S-10 V-6 serpentine set up to swap over on a Small Block. Using that setup do you have to do anything to the power-steering pump or are the pressure settings the same? Where have you mounted the remote reservoir for the power stering?
__________________
My Truck's not leaking its marking its territory! |
12-09-2008, 02:43 PM | #2 |
BAD BOW-Silverado XST
Join Date: May 2000
Location: Senior Member from Austin, TX
Posts: 6,431
|
Re: Serpentine Swap Questions
|
12-09-2008, 02:58 PM | #3 |
Registered User
Join Date: Dec 2007
Location: Palmer, Alaska
Posts: 13,821
|
Re: Serpentine Swap Questions
as long as it is a 4.3 v-6 it is the same as the sbc.
__________________
CHEVY ONLY |
12-09-2008, 03:44 PM | #4 |
Windy Corner of a Dirty Street
Join Date: Jun 2003
Location: Pueblo West, Colorado
Posts: 2,926
|
Re: Serpentine Swap Questions
There is a nice sticky at the top of this page that covers serpentine belt conversions pretty thoroughly.
__________________
Current vehicle collection: 1978 Chevrolet K10, 8.1L, NV4500, NP205 1989 Chevrolet Suburban, 8.1L, NV4500, NP241 1993 Chevrolet C1500 Sportside, TBI 7.4L, 4L60E 2001 Chevrolet K2500HD, Ext Cab, SWB, 8.1L, ZF 6 speed 2014 Chevrolet Impala LTZ 3.6L Vortec 8.1L because life is too short to tolerate underpowered vehicles
|
Bookmarks |
|
|