np 205 rear yoke

[lifted 75 k5]

i recently bought a np 205 for my truck put it in and got everything ready looked at the yoke to make sure it was not for a cv yoke but murphys law got in the way (its a cv yoke ) so what should i do take the driveshaft in or swap the yokes on the t case o by the way its a 75 blazer with eight inches of lift on thirty fives

[1-tonmudder]

Assuming your talkin about the front yoke??? It's not as easy as swappin the yoke,almost all non cv front yokes are 10 spline and the CV yoke is 30 spline,so you will either have to swap the shaft to a 10 spline unit or find a 30 spline non cv yoke.They exist but are kinda rare.

[lifted 75 k5]

actually the rear yoke the guy swapped it out he said for his blazer before he rolled it but anyway the rear yoke

[1-tonmudder]

In that case just swap the yoke.

[lifted 75 k5]

oh ok do you think i can find one in a junk yard somewhere or should i buy one brand new

[1-tonmudder]

If it's just a 1310 yoke I'll have one.What case did you have in it before???

[lifted 75 k5]

it was a 203 before are the rear yokes the interchangeable?

[1-tonmudder]

yeah they are.

[lifted 75 k5]

ok i will have to look at it my buddy says the yoke is bad but he is wrong half the time any way but i will try to pull it out one day this week after school and take a look at it thanks for all your help