|
|
|
04-03-2009, 01:22 PM
|
#1 |
|
dazed and confused
Join Date: Jul 2008
Location: marion nc
Posts: 1,649
|
cutting springs
i have an ece rear drop 6". i dont have the money to buy the spindles and such. has anyone ever cut a 3" front spring just enough to get the truck to level out?
__________________
members met: redbaron69, billsbowtie,nc67 |
|
|
|
04-03-2009, 06:20 PM
|
#2 |
|
resident oilfield trash
Join Date: Jan 2009
Location: Lubbock TX
Posts: 1,465
|
Re: cutting springs
Bad Idea. 3 inches is the most your control arms can handle.
__________________
1967 SWB C10 396/400 factory air factory tach (sadly had to send to a new home) 1986 Honda 70 Fourtrax 1991 Chevrolet K5 blazer 2wd 1982 Mastercraft Pro Star 190 Stars and Stripes 2002 Chevrolet Tahoe 2011 Nissan Armada 
|
|
|
|
|
04-03-2009, 06:22 PM
|
#3 |
|
Registered User
Join Date: Jun 2008
Location: South Florida
Posts: 11,375
|
Re: cutting springs
If you must cut the most you can cut is one coil other than that you need lowering spindles and srop springs.
__________________
Get your facts first, and then you can distort them as much as you please!!!!!. Sylvester's build thread >>>http://67-72chevytrucks.com/vboard/s...ht=big+rebuild |
|
|
|
|
04-03-2009, 06:26 PM
|
#4 |
|
dazed and confused
Join Date: Jul 2008
Location: marion nc
Posts: 1,649
|
Re: cutting springs
yea i was worried about alignment and if it would cause anything to bind.
__________________
members met: redbaron69, billsbowtie,nc67 |
|
|
|
|
04-03-2009, 06:34 PM
|
#5 |
|
Moderator
 
Join Date: May 2007
Location: Southern Cal
Posts: 19,996
|
Re: cutting springs
It will. Save your money and get dropped spindles and do it right.
|
|
|
|
|
04-03-2009, 07:04 PM
|
#6 |
|
dazed and confused
Join Date: Jul 2008
Location: marion nc
Posts: 1,649
|
Re: cutting springs
thanks guys!! this site is alwys helpful!!!!!!
__________________
members met: redbaron69, billsbowtie,nc67 |
|
|
|
 |
| Bookmarks |
|
|
Hybrid Mode
