Register or Log In To remove these advertisements. |
|
|
|
Thread Tools | Display Modes |
|
04-13-2009, 01:08 PM | #1 |
Registered User
Join Date: Aug 2008
Location: Thunder Bay, Ontario
Posts: 94
|
GM Cast Iron Bellhousing Depth
Anyone know how deep a cast iron bellhousing from GM is?\
Aluminum ones are 6 1/4 inches deep. Chime in if you know! Cheers!
__________________
1967 C-10 250 I6 w/ TH350 3.08 10 bolt HUGGER ORANGE aka "The General" '57 GMC short step REGINA SPECIAL 2013 CREW CAB SILVERADO 5.3 6 SPEED Z71 WHITE DAILY DRIVER "When you have eliminated the impossible, whatever remains, however improbable, must be the truth." ~Sherlock Holmes "Deeds will not be less valliant because they are unpraised." ~ Aragorn |
04-13-2009, 01:26 PM | #2 |
Registered User
Join Date: May 2005
Location: PA
Posts: 2,696
|
Re: GM Cast Iron Bellhousing Depth
From what I remember, they are the same.
|
04-13-2009, 03:23 PM | #3 | |
Registered User
Join Date: Aug 2008
Location: Thunder Bay, Ontario
Posts: 94
|
Re: GM Cast Iron Bellhousing Depth
Quote:
I was considering using a bellhousing spacer to move the bellhousing back from the engine which will give me more space to make up for the overall length of the bearing retainer and the input shaft and allow the trans to bolt to the bellhousing. I believe that Brad on here (the guy with Six Appeal!) did not have to cut his T5 input shaft. Thoughts?? Thanks!
__________________
1967 C-10 250 I6 w/ TH350 3.08 10 bolt HUGGER ORANGE aka "The General" '57 GMC short step REGINA SPECIAL 2013 CREW CAB SILVERADO 5.3 6 SPEED Z71 WHITE DAILY DRIVER "When you have eliminated the impossible, whatever remains, however improbable, must be the truth." ~Sherlock Holmes "Deeds will not be less valliant because they are unpraised." ~ Aragorn |
|
Bookmarks |
|
|