sandblast and por and paint

[packers05]

just got done with frame and axles, i sandblasted all of it yesterday. sprayed the por 15 this morning and shot some urethane with flattener to soften the shine, looks good enough for me,now lets get back to the tub.

[OARNGESI]

That looks really good

[Gary 70 Jimmy]

nice job I like por15

[lolife99]

I thought POR-15 need rust to adhere to? Why wouldn't you just use paint products if you go to all the work to sand blast the metal clean? Just asking.

[packers05]

I read the directions after i sprayed it,big mistake, now i am wondering if i should just quit now, maybe blast it off again and get it rusty? Or does it say on the can to apply to sandblasted metal? seems to me that por is a great product that will look good as base for paint that will chip and scratch off! Good question though.

[DURRTY]

I have used POR15 on my blazer frame, it was rusty. I also have made and painted POR15 on some small parts unrelated to the blazer.

I made a tow ring to go into a 2x2 reciver, like a tow pintle. I sandblasted it then used some acid just like metal ready from POR. and painted the stuff on it.


it hasn't flaked or chipped, the POR15 is like a powder coat, you could tell someone it was powder coat and they would most likely never know the difference. I have dropped the thing on the ground and has some scratches and stuff but not actual flakes or chips.

I don't know any of the science of por15 and I could be wrong BUT I would trust your work as long as you followed the prep directions and let it cure like it says . POR15 is some seriously sticky and thick stuff, hell it wont come off your hands for a week!


another thing is the directions say to use POR metal ready, wich is phosphoric acid and zinc phosphate(or something like that) it "neutralizes rust" so that would be close to blasted metal.

I would not sweat it and it looks outstanding, nice work.

[leddzepp]

Originally Posted by packers05

I read the directions after i sprayed it,big mistake, now i am wondering if i should just quit now, maybe blast it off again and get it rusty? Or does it say on the can to apply to sandblasted metal? seems to me that por is a great product that will look good as base for paint that will chip and scratch off! Good question though.

Haha...good luck trying to take it off! It will adhere to clean metal just as good as rusty metal.

[Skirkpat]

You are fine, it etches into the metal, or nuetralized rust. POR 15 is supposed to be covered with a top coat, according to my local paint supplier. If at all possible with a UV resistant paint.

[packers05]

thanks for all the comments ,I have my vortec 350 put together so i need to get this thing back together

[70 Suburban]

you can apply to prepped clean metal. sand blasting leave a giid bite for it. you should be fine. i would be more worried that you ddint give it time to cure before top coat

[70 Suburban]

im about to use it on my 65

[mrh33916]

I really like POR-15 because you can do as much or as little prep as you want. If parts of the chassis will be seen I spend extra time sandblasting the rust away, If it's a part that wont be seen you can just put the POR-15 directly on the rust. It also does a great job of filling the pits left over from the rust, just put it on heavy as it's self leveling. As for bare metal I sandblast many small parts like bumper brackets...etc in a blasting cabinet then apply POR-15. It is rock solid. It will stick to sandblasted metal better than shiney metal after grinding.