|
Register or Log In To remove these advertisements. |
|
|
|
|||||||
 |
|
|
Thread Tools | Display Modes |
|
|
12-26-2002, 12:10 PM
|
#1 |
|
Life is Good !
Join Date: Mar 2002
Location: Hollister, Ca.
Posts: 1,992
|
tilt steering question ??
I was thinking about putting a tilt steering colum in my '72. I want to put one out of a 1998-2002 chevy truck. Is this possable or am I wasting my time? Just wanted some input from the board. Because there are a lot of you guys that have been doing this longer than I have. Thanks Guys Landon
__________________
'72 Chevy C10 4x4 shortbed "Project" '71 Chevy C10 2wd longbed "partsrunner" '91 Chevy Burb 4x4 "kidrunner" '14 Honda Accord Sport "commuter" |
|
|
|
12-26-2002, 05:20 PM
|
#2 |
|
1969 Custom 30 wrecker
Join Date: Sep 2001
Location: Pottsville, Pa
Posts: 2,611
|
Anything can be done, just watch Monster garage! LOL
Seriously, I would look it over carefully and take lots of measurments. If it looks like it will install without any serious mods, then go for it. My '69 has a tilt/telescopic from a late 70's Caddy and very little mods were done. I bought my truck with it in but as far as I can tell, only some trimming to the speedometer bezel was needed. Everything else appears untouched.
__________________
Bob 63 Impala 283/PG/3.36 (under restoration) 66 Impala 327/PG/3.36 66 Chevelle SS 409/M22/3.55 69 Chevelle 307/PG/3.08 (future restoration) 69 C10 short stepside 454/TH350/3.73 69 Custom 30 tow truck 350/4 spd/4.10 (resto done, CRUISIN TIME!) 71 Cheyenne 20 fleetside 350/4 spd/4.10 71 Chevelle 6/PG/3.08 72 Chevelle 454/M21/4.10 |
|
|
|
|
| Bookmarks |
|
|
Hybrid Mode
