Going to pick up my '67

[jimmybeus]

I'm going over to my parents house where my '67 has been sitting for the last ten years. I was going to try and put the '94 TBI motor in it but after reading all that is involved I think I will just carb it out till I can get a better fuel inj. motor. Questions: Where is the best place to get the motor mounts that will go from a 292 to a 350? Or do I take the blocks off the 67 frame rails and then will it be set up for a 350? Is there a place that sells intake and carb set up for this conversion or does someone know what I will need? Can I use the old 4 speed transmission with newer motor? Eventually I want to put a 4l60e behind it but for now just want to get it running and driveable. I dont have a lot of money to work with right now so I am trying to get by with what I have at my disposal. The donor truck is a 1994 chev 4x4. I figured the 5 speed out of that truck wont work where it has a transfer case on it. Any suggestions or advice greatly appreciated. Try and post some pics tomorrow after I get it home.
Sorry if this is long winded but after looking at the post and pics on here, it has really got me pumped to start on the ol project again. Thanks

[19673ontree]

it is a $100 fine and six month's in jail to make a post like this without pic's
better get some pic's QUICK before someone see's this

[jimmybeus]

Well I got the '67 home today. Here are some pictures of the ol gal. My grandfather purchased new then gave it to my dad and then, before I was old enough to drive, it was handed down to me. It hasn't ran in about 15 years. I tried replacing the fuel pump, cleaned the tank, rebuilt the carb but still couldnt get it running. Now that I have this donor truck I want to put a whole different set up in it.