![]() |
Register or Log In To remove these advertisements. |
|
|
![]() |
|
Thread Tools | Display Modes |
|
![]() |
#1 |
Registered User
![]() Join Date: Nov 2008
Location: Cape cod, ma.
Posts: 394
|
71 gmc non tilt column question
hey guys i replaced my tilt column with a non tilt auto on the column and the thread on the end of the shaft by the steering wheel is a different size than the tilt one. does anybody know what size nut it takes to bolt the steering wheel on? this is after 2 trips to the hardware store with the wrong size nut. the tilt shaft was 1/2 inch and is too small for the non tilt column. i tried 9/16 fine thread but that was too big. any ideas?
|
![]() |
![]() |
![]() |
#2 |
Registered User
![]() Join Date: Nov 2008
Location: Cape cod, ma.
Posts: 394
|
Re: 71 gmc non tilt column question
?
??? |
![]() |
![]() |
![]() |
#3 |
TILT COLUMN GURU
![]() Join Date: Dec 2006
Location: FRESNO CA
Posts: 4,276
|
Re: 71 gmc non tilt column question
Should be !/2" fine thread
__________________
kevs_classics64 64 Impala SS Conv 72 Blazer 2wd 75 Jimmy 2wd 63 Belair wagon 02 Silverado ext cab. DD RIP EL JAY |
![]() |
![]() |
![]() |
Bookmarks |
|
|