|
06-08-2010, 02:55 PM | #1 |
Senior Member
Join Date: Sep 2007
Location: Albuquerque NM
Posts: 7,862
|
sway bar installation
I just swapped my 67 1/2 ton longbed to front disk and picked up a 1 1/4" sway bar and cut 3/4" of both ends (double measured) to accomodate for the 2600 dominator airbags I installed while swapping hub and control arm assys.. When I mounted the sway bar up with new bushings it doesnt sit equally on the lower control arms. The passenger side is sitting actually juuust inside the bushing mount while the driver side sticks out of the mount about 3/4 of an inch. Am I doing something wrong here that the sway bar isint being centered.
Origionally, as you all know it was a 6 lug drum, converted to a 72 front end. and it origionally had a 7/8" sway bar so I never relocated the mounts on the frame horns. any ideas as to what Im doing wrong here guys?
__________________
1967custom |
06-08-2010, 04:07 PM | #2 |
Between Trucks...
Join Date: Mar 2002
Location: Los Angeles, CA.
Posts: 3,830
|
Re: sway bar installation
Could the swaybar be bent?
__________________
Beat it to fit, Paint it to match... |
06-08-2010, 07:18 PM | #3 |
Senior Member
Join Date: Sep 2007
Location: Albuquerque NM
Posts: 7,862
|
Re: sway bar installation
no I dont think so, the truck it came from was pretty babied and it looks real symmetrical Ill match it up to the other one I have and make sure the bends are the same
__________________
1967custom |
Bookmarks |
|
|