New Poster with Differential ID question - The 1947 - Present Chevrolet & GMC Truck Message Board Network

swiftwater15 · 03-15-2011, 02:39 PM

I'm restoring my grandads '72 Fleetside, the truck I learned to drive in. I'm trying to Id the rear axle. It was a ranch truck with 64k original miles, but most of them at about 10 mph bouncing around the dirt roads.

12 bolts holding the rear cover. "GM60" cast into the front driver's side of the casting. "NF3896838" cast into the passenger side casting. Five bolt axles, with 16" rims and heavy spring options.

If this a Dana 60, GM 12 bolt or . . .?

Thanks in advance. Tried a search and didn't find an answer.

Dan

**kwmech** · 03-15-2011, 04:02 PM

1/2 ton? 3/4 ton. A Dana 60 cover will have 10 bolts. 12 bolt will have 12 bolts

Longhorn Man · 03-15-2011, 04:33 PM

a GM 12 bolt. It's a 1/2 ton truck.

**DANTIP** · 03-15-2011, 07:47 PM

If you want more information about the gear set, you can look for the axle tube stamp as shown in the sketch (don't pay attention to the casting numbers on the sketch, I borrowed them from a Camaro or Chevelle web site). The stamped code will have the axle code and a coded plant and build date. If you find the stamped code, post it and someone will look it up for you.

03-15-2011, 02:39 PM	#1
swiftwater15 Registered User Join Date: Mar 2006 Location: Washington Posts: 3	New Poster with Differential ID question I'm restoring my grandads '72 Fleetside, the truck I learned to drive in. I'm trying to Id the rear axle. It was a ranch truck with 64k original miles, but most of them at about 10 mph bouncing around the dirt roads. 12 bolts holding the rear cover. "GM60" cast into the front driver's side of the casting. "NF3896838" cast into the passenger side casting. Five bolt axles, with 16" rims and heavy spring options. If this a Dana 60, GM 12 bolt or . . .? Thanks in advance. Tried a search and didn't find an answer. Dan

03-15-2011, 04:02 PM	#2
kwmech Senior Member Join Date: Mar 2003 Location: Colfax-California Posts: 8,630	Re: New Poster with Differential ID question 1/2 ton? 3/4 ton. A Dana 60 cover will have 10 bolts. 12 bolt will have 12 bolts

03-15-2011, 04:33 PM	#3
Longhorn Man its all about the +6 inches Join Date: Jan 2001 Location: Hilliard Ohio Posts: 2,690	Re: New Poster with Differential ID question a GM 12 bolt. It's a 1/2 ton truck.

03-15-2011, 07:47 PM	#4
DANTIP Registered User Join Date: Sep 2001 Location: Fort Wayne, Indiana, USA Posts: 1,888	Re: New Poster with Differential ID question If you want more information about the gear set, you can look for the axle tube stamp as shown in the sketch (don't pay attention to the casting numbers on the sketch, I borrowed them from a Camaro or Chevelle web site). The stamped code will have the axle code and a coded plant and build date. If you find the stamped code, post it and someone will look it up for you. Attached Images Last edited by DANTIP; 03-15-2011 at 07:50 PM.



Register or Log In To remove these advertisements.

Register or Log In To remove these advertisements.