Register or Log In To remove these advertisements. |
|
|
|
Thread Tools | Display Modes |
|
04-21-2011, 10:42 AM | #1 |
Account Suspended
Join Date: Sep 2010
Location: hingham ma
Posts: 1,721
|
th350 space for service
Hello I have my 2 piece driveshaft out as it needed a new center carrier bearing , so I replaced the u joints..
and I'm going to replace the tailshaft seal my question is does anyone know if there is enough room to slide the th350 back while bolted to the crossmember but crossmember unbolted from frame and drop the converter to change out the front seal .. thanks.. |
04-21-2011, 12:54 PM | #2 |
"the other guy"
Join Date: Oct 2008
Location: Olivehurst California 95961
Posts: 901
|
Re: th350 space for service
that's how i do it. i position my floor jack under the trans pan parallel to the truck, and use a hammer to "tap" on the crossmember. it will slowly walk away from the engine. baby steps though
__________________
God Said,"Building A 10 Second Import Is Like Coming Out Of The Closet, In The End Ur Still....."EXPLETIVE" |
04-21-2011, 08:41 PM | #3 |
its all about the +6 inches
Join Date: Jan 2001
Location: Hilliard Ohio
Posts: 2,690
|
Re: th350 space for service
i never thought of doing this... there's room, but in reality, I see it as more of a pain than just dropping the trans, and I would be scared of it falling for one reason or another.
|
04-21-2011, 08:52 PM | #4 |
Registered User
Join Date: Aug 2009
Location: St. Paul MN.
Posts: 1,996
|
Re: th350 space for service
I would drop the cross member and pull the trans if you are installing a front seal. And if the trans is old I also at that time install a new pump seal.
__________________
Fuzzy |
Bookmarks |
|
|