![]() |
Register or Log In To remove these advertisements. |
|
|
![]() |
|
Thread Tools | Display Modes |
|
![]() |
#1 |
Registered User
Join Date: Oct 2009
Location: stouffville ontario
Posts: 166
|
column to floor shifter
hey guys can i get some ideas on how hard the converstion is to change a column shifter to floor shifter? im getting a new 4 speed auto anyways and was wondering if it would be worth it to get a new 4 speed column or just go 4 on the floor. thanks for any input its really appreciated
|
![]() |
![]() |
![]() |
#2 |
Registered User
Join Date: Jun 2011
Location: Baytown TX
Posts: 2,219
|
Re: column to floor shifter
Both are easy, pic what you prefer and go for it.
__________________
John 82 Chevy Silverado 350ci/TH350 ![]() |
![]() |
![]() |
![]() |
#3 |
Registered User
Join Date: Oct 2009
Location: stouffville ontario
Posts: 166
|
Re: column to floor shifter
but how easy is easy? i would love a floor shifter but what do i need to do
|
![]() |
![]() |
![]() |
#4 |
Registered User
Join Date: Jun 2011
Location: Baytown TX
Posts: 2,219
|
Re: column to floor shifter
Basicly shop for the floor shift you want (4spd compatable). Remove column gear shift level and linkage to tranny. Mount new shifter it to floor, run cable to tranny, run wires for neutral safety switch and reverse light. There will be directions for specifics to the shifter you pic.
__________________
John 82 Chevy Silverado 350ci/TH350 ![]() |
![]() |
![]() |
![]() |
#5 |
Formerly LSC71
Join Date: Feb 2004
Location: Indiana
Posts: 186
|
Re: column to floor shifter
When I did the swap from 3spd to TH350 auto, I bought a floor shifter kit from Gennie Shifter. Wasn't hard at all. Like posted before, you will remove the linkage from the previous column shift to get it out of the way. With the Gennie kit, I bolted the new hardware onto the trans, put it back in position and marked the underside of the tunnel where the shift lever would now be coming through, pulled the trans back out of the way. Dilled some pilot holes from the bottom to mark the area that needed cut out, then from the inside used a die grinder to connect the dots. Put the trans back in. Attached the shif lever, adjusted the new linkage and was in business. Hope that helps.
|
![]() |
![]() |
![]() |
#6 | |
Registered User
Join Date: Jun 2011
Location: Baytown TX
Posts: 2,219
|
Re: column to floor shifter
Quote:
__________________
John 82 Chevy Silverado 350ci/TH350 ![]() |
|
![]() |
![]() |
![]() |
Bookmarks |
|
|