|
Register or Log In To remove these advertisements. |
|
|
|
|||||||
 |
|
|
Thread Tools | Display Modes |
|
|
11-07-2011, 10:38 AM
|
#1 |
|
Registered User
Join Date: Jul 2011
Location: Turkey, N.C.
Posts: 21
|
3/4 ton Hub and Wheel Bearing Ques?
Hey guys im tearing dowm my rear axle and have a ques? I have pulled the drum off the hub and removed the snap ring for the outer wheel bearing. But the bearing will still not come out. Am i missing something or does it need some force?
|
|
|
|
11-07-2011, 12:38 PM
|
#2 |
|
Windy Corner of a Dirty Street
Join Date: Jun 2003
Location: Pueblo West, Colorado
Posts: 2,926
|
Re: 3/4 ton Hub and Wheel Bearing Ques?
Been a while since I replaced bearings on a full-floater but I believe you must tab the race out in order to get the bearing out. They push out the front side. I believe the clip is there just to keep the race from being pushed in too far.
__________________
Current vehicle collection: 1978 Chevrolet K10, 8.1L, NV4500, NP205 1989 Chevrolet Suburban, 8.1L, NV4500, NP241 1993 Chevrolet C1500 Sportside, TBI 7.4L, 4L60E 2001 Chevrolet K2500HD, Ext Cab, SWB, 8.1L, ZF 6 speed 2014 Chevrolet Impala LTZ 3.6L Vortec 8.1L because life is too short to tolerate underpowered vehicles
|
|
|
|
|
11-07-2011, 05:27 PM
|
#3 |
|
Registered User
Join Date: Jul 2011
Location: Turkey, N.C.
Posts: 21
|
Re: 3/4 ton Hub and Wheel Bearing Ques?
Thanks for the input Dirty Larry! I was thinking that would be the only way just wanted some confirmation. Thats a hell of a K10 you have built yourself!
|
|
|
|
|
| Bookmarks |
|
|
Hybrid Mode
