How fast in your ol truck

[Super C10]

So the other day was comin home and got bored so i wanted to see how fast my old super would go so hammered down and got the speedo to come around and touch 10 again lol. Mined you this truck has a so what stock 350 backed with a turbo 350 and 3.08 gears. Look it up online with the engine tranny and rear gears at 5300 rpm it was real close to 155 some thing like 152 mph really. Next time the front end will be new but she floated like a cadallic down the road i was surprised it didnt pull. It wasnt to concerning till i thought about it later lol

Post up what you guys have done i wanna hear the storys guys

[eurospec1]

Not to burst your bubble, but a stock 350 is not going to push these heavy un-aerodynamic slugs to 152 MPH, something has to be off in the calculations.

[BLOWN72]

I do not run top end, for sure with an old truck like these. I will be getting this truck to the track next year to see what it runs. I'm expecting good things with the power I am pushing. Yeah 152mph is hard to believe but I guess anything could be possible. I had a buddy with a a 94 sonoma 4.3L which didn't have a govoner that would top out around 135-140

[Super C10]

I say stock engine compared to some people on the fourms. All it is 87 350 block, mild cam, centerbolt caprice cop car heads, aluminum edelbrock intake and carb. Pretty much stock compared to the 454s and supercharged small blocks on this fourm. Dont got that kinda money for a fancy motor. Also not sayin the calculator was or wasnt correct but until i find any other proof i will use it.

[hjewell2]

Originally Posted by Super C10

I say stock engine compared to some people on the fourms. All it is 87 350 block, mild cam, centerbolt caprice cop car heads, aluminum edelbrock intake and carb. Pretty much stock compared to the 454s and supercharged small blocks on this fourm. Dont got that kinda money for a fancy motor. Also not sayin the calculator was or wasnt correct but until i find any other proof i will use it.

Try this site www.wallaceracing.com/Calculators.htm

[eurospec1]

Originally Posted by Super C10

I say stock engine compared to some people on the fourms. All it is 87 350 block, mild cam, centerbolt caprice cop car heads, aluminum edelbrock intake and carb. Pretty much stock compared to the 454s and supercharged small blocks on this fourm. Dont got that kinda money for a fancy motor. Also not sayin the calculator was or wasnt correct but until i find any other proof i will use it.

What calculator did you use, and what did you input to get this speed calculation? Reason i ask is you did not mention tire size, which also is a huge factor in determining top speed, RPM, trans Gear, Rear gear all determine how fast your axles are turning, how far you travel per each rotation of the axle is (IE Speed) then determined by tire height.

[hjewell2]

Using your vehicle Speed of 152 MPH takes 172.61 HP to overcome air drag.
Rolling resistance is 20.02
For a total of 192.64 HP to run 152 MPH

[big_al_71]

this is about a month ago which is the last time I drove my truck before I tore it apart for suspension and brakes upgrade......Plenty of throttle left look at the RPM's I will post picts of it next time I go on the highway and let's see where it will top out at...

Thats a 406 with 373 gears....

[96blazr]

Originally Posted by Super C10

So the other day was comin home and got bored so i wanted to see how fast my old super would go so hammered down. Mined you this truck has a so what stock 350 backed with a turbo 350 and 3.08 gears. Look it up online with the engine tranny and rear gears at 5300 rpm it was real close to 155 some thing like 152 mph really. I wasnt to concerning till i thought about it later lol

Originally Posted by hjewell2

Using your vehicle Speed of 152 MPH takes 172.61 HP to overcome air drag.
Rolling resistance is 20.02
For a total of 192.64 HP to run 152 MPH

Really? You got "bored" and did 152? Really?
Too damn funny Seriously, I think you better check your speedo cable and follow hjewell2's calculations.
You kids these days, you crack me up.
HEY, since I have a SWB that means I can go at least 156 due to a shorter bed!! Yeah, that's right!!

[eurospec1]

Originally Posted by 96blazr

Really? You got "bored" and did 152? Really?
Too damn funny Seriously, I think you better check your speedo cable and follow hjewell2's calculations.
You kids these days, you crack me up.
HEY, since I have a SWB that means I can go at least 156 due to a shorter bed!! Yeah, that's right!!

My 383 outta bust 200 then me thinks...But only when i'm bored

[TrkEnvy]

Originally Posted by hjewell2

Using your vehicle Speed of 152 MPH takes 172.61 HP to overcome air drag.
Rolling resistance is 20.02
For a total of 192.64 HP to run 152 MPH

I dont think its just about the horsepower though, you gotta factor aerodynamics too.. The fastest I have ever gone in a vehicle was a documented 142 mph via unmanned radar checkpoint.. lol It was in my 02 mustang gt. 303 hp on a chassis dyno, lowered 2 inches on 18 inch wheels. The front end was light and my hood was vibrating like an old massage bed. I dont even wanna think about my 71 at 140, let alone 152..

[72GMCK-2500]

I got to 82 MPH when i saw a state pooper in my 72 GMC 2500 4x4. Luckily he wasnt shooting radar, but keep in mind shes totally stock 350 and 4 speed with granny, all original with over 228,000 miles! Not bad for an old plow truck. It was kinda scary because she was floatin all over the turnpike at those speeds.

[rpmerf]

70 c20 350 3 speed, 8.0:1 compression with matched cam

only had it up to around 90-95 ish

felt pretty solid, but with no tach and drum brakes I didn't want to push it further

[domeier]

I'd like to get my truck on a drag strip someday and see what kind of 1/4 mile it would run. 330 hp 350, th350, 3:73 gears and 50,000 lbs of front axle and transfer case. It's awful quick for an old 4x4. I whupped up on some kid in a Mazda RX-8 the other day who apparently thought I was in his way. I didn't even have to floor it to keep him from passing me. That poor little dude is gonna have erectile dysfunction for the rest of his life.

[srea76]

Id suggest you throw a gps in the cab with ya and find out the speed.

[a_barth]

I'm not sure but it looks like your running about a 30" tire. From what I figure your estimate would be pretty close in a perfect world with a manual or a lock-up convertor, but with a standard th350 the absolute best you could achieve would be 90% fluid coupling in the convertor (unlikely) so assuming a conservative convertor slippage of 85% you are looking at more like 130, which I could maybe see possible on a really long flat road with a major tail-wind.

[eurospec1]

Originally Posted by a_barth

I'm not sure but it looks like your running about a 30" tire. From what I figure your estimate would be pretty close in a perfect world with a manual or a lock-up convertor, but with a standard th350 the absolute best you could achieve would be 90% fluid coupling in the convertor (unlikely) so assuming a conservative convertor slippage of 85% you are looking at more like 130, which I could maybe see possible on a really long flat road with a major tail-wind.

He's not talking about the 4x4 he's talking about his "lowered project" which I assume will have a much shorter tire. There's no way on gods green earth that 4x4 hit 150 mph....
Posted via Mobile Device

[a_barth]

ok sorry I thought he was talking about the one in his avatar.

[Andy4639]

I drive my truck to my parents all the time and have hit 85 90 MPH very often. The truck handles fine at that speed. The only problem I have is if something was to blow at that speed. I don't do it as often but as stated going up the interstate it has seen some high numbers.

[crazy longhorn]

The tach & speedo jive with the calculator ....3000 on the tach is 100 mph in overdrive. (3.42 gears,.76 OD, & 29.1" tires). So how fast is my Longhorn running, when reading 15-20 mph on the 2nd trip? I never have checked that tach @ that speed(too busy watching the road!)...but my guess is a tick over 140 mph. crazyL

[50bomb]

Originally Posted by a_barth

ok sorry I thought he was talking about the one in his avatar.

haaaaaaa!!! That is the Super lowered project in the avatar that he is talking about

[Already Gone]

Originally Posted by srea76

Id suggest you throw a gps in the cab with ya and find out the speed.

That is exactly what I did with ole Pinky last year. I wasn't topped out and wasn't trying to do that but with some pedal still left my GPS said I was doing 93MPH and the speedo said 95MPH, close enough for me and the truck was real tight and riding smooth at that speed. My truck has a 396 ( and I don't know the specs) with a TH400 and 3:73's.

[redhead69]

95 mph in 1320 feet

[1972RedNeck]

Originally Posted by Super C10

Look it up online with the engine tranny and rear gears at 5300 rpm it was real close to 155 some thing like 152 mph really.

By using my own simple calculator I deduce that you are running about 2100 RPM @ 60 MPH. Is this correct? If so, 5300 RPM = 150 MPH.

[HalfTon]

I hit 90mph a few nights ago. The highway was completly empty and I wanted to see what my truck would do. When I got up to 85 my mirrors went into aerodynamics mode and folded in from the wind and the door windows started to rattle a bit but overall I was surprised at how it felt at that speed. 360hp 355, th350, 3:08