![]() |
Register or Log In To remove these advertisements. |
|
|
![]() |
|
Thread Tools | Display Modes |
|
![]() |
#1 |
Registered User
Join Date: Sep 2010
Location: southwest ohio
Posts: 82
|
NP205 Front Output Shaft
I was going to replace the seal on the front output shaft of my 205, so I undid the 4 bolts around the seal housing, and took off that 1 1/8" nut holding the flange on. The flange wouldn't slide out like normal, so I used a puller and pulled it off.
Now when getting it back on, I can't get it far enough on by hand to start the nut on the thread. Still got 1/4 - 1/2" to go before I can get the nut on. I don't want to hit it with a hammer, so what are my options? Thanks |
![]() |
![]() |
![]() |
#2 |
Registered User
Join Date: Sep 2010
Location: southwest ohio
Posts: 82
|
Re: NP205 Front Output Shaft
Nevermind. I took a flat screwdriver and scraped it along each groove in the spline on the flange, and the spline on the TC, it knocked a bunch of crap out of the splines, and then it slid on like butter.
|
![]() |
![]() |
![]() |
Bookmarks |
|
|